Best Frsky X4r

HAPPYMODEL Mobula6 1S 65mm Brushless Whoop Drone Mobula 6 BNF AIO 4IN1 Crazybee F4 Lite Flight Controller Built-in 5.8G VTX RC Toy Gift (25000KV Frsky)

Flight Controller: (Frsky SPI RX Version) CRAZYBEE F4 Lite Frsky version Firmware target: CrazybeeF4FR.
(Flysky SPI RX Version) CRAZYBEE F4 Lite Flysky version Firmware target: CrazybeeF4FS.
Receiver Option: Internal SPI Frsky Version (Compatible with ACCST D8/D16, Recommend Non EU transmitter D8 mode).
Internal SPI Flysky version(Compatible with AFHDS 8CH and AFHDS-2A 14CH Flysky transmitter).
Motor Speed Option: SE0802 KV25000(Race Edition).
Onboard 4in1 ESC : Support BLHeliSuite Programmable.
AIO 4IN1 Crazybee F4 Lite Flight Controller built-in 5.8G VTX.
Extreme Light 1S 65mm Brushless Whoop only 20g.
Runcam Nano3 The Lightest 1/3 CMOS 800TVL Camera.

Parallel two X8R to become a 16 channel receiver..
SmartPort enabled, realizing two-way full duplex transmission..
More number of channels: 1~8ch from conventional channel outputs, 1~16ch from SBUS port,or combine two X8R to become a 16 channels receiver..
All 16 channels requires the FrSky Taranis, or the XJT module bound in D16 mode. For 8 channels in D8 Mode you can use the FrSky Taranis or XJT, DJT, DFT, DHT and DHT-U modules..

【Upgrade】Classical BETAFPV F4 1S brushed flight controller V2.0 comes back with a new cross particular shape, and it adopts BT2.0 connector cable instead of BT2.0. It is compatible with Beta65S 1S brushed whoop drone..
【Protocol】Build-in CC2500 chip, the default protocol is configured to Frsky D8 out of the factory and can be adjusted to Frsky D16 FCC, Frsky D16 LBT, or Futaba. Pilots could set up the protocol according to their needs in Betaflight Configurator..
【Cable】The power cable applies BT2.0 connector instead of PH2.0, which solves the problem of voltage sag, and the discharge can be more efficient, bringing this board a better performance on function for power and responsiveness..
【RGB】It supports custom RGB lights on the Betaflight configuration, you can DIY it by your hobby, which makes your drone unique from others..
【Support】Firmware and Cli Dump file for F4 Brushed Flight Controller, some basic guidance and typical FAQ, please visit our official website..

Receiver option: Internal SPI Frsky version (Compatible with ACCST D8/D16, Recommend D8 mode).
Motor speed option: SE0802 KV19000(Regular Edition).
Extreme light 1S 65mm Brushless whoop only 20g , Runcam Nano3 The lightest 1/3 CMOS 800TVL Camera.
8CH Remote Controller System: Bayang Protocol / Frsky Protocol.
Controller LED Light: Green-Power On / Red-Warning / Blue-Normal.

Receiver option: Internal SPI Frsky version (Compatible with ACCST D8/D16, Recommend D8 mode).
Mobula6 HD Come with Runcam Split3-lite 1080P HD DVR , Extreme light 1S 65mm Brushless HD only 27g.
LiteRadio 2 Radio Transmitter System: Bayang Protocol / Frsky Protocol.
Transmitter LED Light: Green-Power On / Red-Warning / Blue-Normal.
Package include: Mobula6 HD + LiteRadio 2 Radio Transmitter ( Mode 2 ).

Flight controller: (Frsky SPI RX version) CRAZYBEE F4 Lite Frsky version Firmware target: CrazybeeF4FR.
(Flysky SPI RX version) CRAZYBEE F4 Lite Flysky version Firmware target: CrazybeeF4FS.
Onboard 4in1 ESC: MCU upgraded to EFM8BB21.
Current: 5A continuous peak 6A (3 seconds).
OnboardFrsky SPI D8 receiver Version: SPI BUS receiver Frsky D8 compatible.
No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m.
OnboardFlysky SPIreceiver Version: SPI BUS receiver.
No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m.

High Quality Universal RC Controller Carrying Case Bag for Jumper WFLY RadioLink FrSky Transmitter.
Durable, portable and lightweight, fit for most RC radio transmitter, like Jumper T8SG Plus V3, T12 Pro,T16 Pro Hall V2, T18 T18 Pro, T18 Lite, WFLY WFT07, WFT09, ET07, WFT07, RadioLink AT9, AT9S, AT10 and FrSky X9D.
Two-way z1pper design and rubber handle , well protect your device from bumps dents and scratches.
High-density foam interior with pre-cut compartments for the transmitter and accessories.
Note: Some transmitter might require trimming of the foam insert to fit properly.

Note: FrSky Taranis Q x7 defualt package aren't include the battery and battery trays.New version with a Charing port on the side and no longer includes a battery tray..
Multiple Battery Options: Battery: 800mAh NiMH/ 1800mAh LSD NiMH/ 2S LiPO Battery (Optional Accessories) Charger: FCX07 Li/NiMH Dual Mode Charger (Optional Accessories).
Super Low Latency Vibration Alerts Model configuration files compatible with TARANIS X9D Plus.
Real-time Flight Data Logging Receiver Signal Strength Indicator (RSSI) Alerts.
Compatibility: FrSky X series, D series and V8-II series receivers (plus other receivers if an external module is used) Get into FPV for beginners If you have any problem, feel free to contact us with detailed information and bar code. Our technology support team will help check and solve the problem. In addition, we also have US support center. If you want, you can also call them or return it back to them and they can fix it for you..

Flight controller: CRAZYBEE F4 Lite Firmware target: Frsky SPI RX version is CrazybeeF4FR.
Flysky version is Crazybee F4FS. Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready. Built-in Betaflight OSD(SPI Control). Built-in 5.8G VTX. Built-in SPI Frsky/Flysky receiver. Built-in 5V 1A BEC. Built-in voltage detection..
Onboard 4in1 ESC: MCU upgraded to EFM8BB21 Power supply: 1S LiPo/LiPo HV Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: O_H_5_REV16_7.HEX Default protocol: DSHOT600.
Runcam Nano3: Horizontal Resolution: 800TVL Lens : 2.1mm(M8) FOV 160° Signal System: PAL/NTSC Non Switchable Day/Night: Color.
Onboard 5.8g 40-CH 25mw VTX: Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels Smartaudio ready.