Best Differential Amplifiers

Juried Engineering RC4136N RC4136 Quad Low Noise 30V Operational Amplifier Op Amp Breadboard-Friendly IC DIP-14 (Pack of 5)

  • High common-mode input voltage range and the absence of latch-up.
  • Continuous Short-Circuit Protection, Designed To Be Interchangeable With Raytheon RC4136, RM4136, and RV4136.
  • Wide Common-Mode and Differential Voltage Ranges.
  • No Frequency Compensation Required, Gain and Phase Match Between Amplifiers, Low Noise ...8 nV Typ at 1 kHz.
  • Low Power Consumption, No Latch-Up, Unity-Gain Bandwidth ...3 MHz Typ.
Check Stock

Juried Engineering TL074CN TL074 Quad Low-Noise JFET-Input Operational Amplifier Breadboard-Friendly IC DIP-14 (1 Piece)

  • The TL074 Quad JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit.
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

Juried Engineering TL081CP TL081 High Slew Rate JFET-Input Operational Amplifier Op-Amp IC Breadboard-Friendly DIP-8 (1 Piece)

  • The TL081CP JFET-input operational amplifier family is designed to offer a wider selection than any previously developed operational amplifier family. Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit..
  • Low Power Consumption: 1.4 mA/ch Typical, Low Input Bias Current: 30 pA, Typical Low Input Offset Current: 5 pA Typical, High Slew Rate: 13 V/μs Typical.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% Typical, Wide Common-Mode and Differential Voltage Ranges, Common-Mode Input Voltage Range Includes VCC+.
  • High Input Impedance: JFET Input Stage, Latch-Up-Free Operation.
  • Example Applications: Tablets, White goods, Personal electronics, Computers.
Check Stock

Juried Engineering TL081CP TL081 High Slew Rate JFET-Input Operational Amplifier Op-Amp IC Breadboard-Friendly DIP-8 (Pack of 10)

  • The TL081CP JFET-input operational amplifier family is designed to offer a wider selection than any previously developed operational amplifier family. Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit..
  • Low Power Consumption: 1.4 mA/ch Typical, Low Input Bias Current: 30 pA, Typical Low Input Offset Current: 5 pA Typical, High Slew Rate: 13 V/μs Typical.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% Typical, Wide Common-Mode and Differential Voltage Ranges, Common-Mode Input Voltage Range Includes VCC+.
  • High Input Impedance: JFET Input Stage, Latch-Up-Free Operation.
  • Example Applications: Tablets, White goods, Personal electronics, Computers.
Check Stock

Juried Engineering TL072CP TL072 IC JFET Operational Amplifier & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 5)

  • The TL072 JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low-input bias and offset currents, and low offset-voltage temperature coefficient..
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

Juried Engineering LM324N LM324 Quadruple Independent High-Gain Frequency-Compensated Operational Amplifier Op-Amp IC DIP-14 14-PIN DIP Breadboard-Friendly (Pack of 3)

  • The LM324 consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply or split supply over a wide range of voltages..
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA Typical, Wide Supply Ranges:003c/b003e Single Supply: 3 V to 32 V Dual Supplies: ±1.5 V to ±16 V.
  • Low Input Bias and Offset Parameters - Input Offset Voltage: 3 mV Typical - Input Offset Current: 2 nA Typical - Input Bias Current: 20 nA Typical.
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground.
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V.
Check Stock

Juried Engineering LM324N LM324 Quadruple Independent High-Gain Frequency-Compensated Operational Amplifier Op-Amp IC DIP-14 14-PIN DIP Breadboard-Friendly (Pack of 10)

  • The LM324 consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply or split supply over a wide range of voltages..
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA Typical, Wide Supply Ranges:003c/b003e Single Supply: 3 V to 32 V Dual Supplies: ±1.5 V to ±16 V.
  • Low Input Bias and Offset Parameters - Input Offset Voltage: 3 mV Typical - Input Offset Current: 2 nA Typical - Input Bias Current: 20 nA Typical.
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground.
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V.
Check Stock

Taidacent THS4131 Fully Differential Input/Output Low Noise Amplifier Module Single Ended to Differential Single Ended Input Double Ended Output

  • Name: THS4131 Fully Differential Amplifier Size: 45mm X 34mm Supply Voltage Range: 5V Single Supply ±15V Dual Supply.
  • This module can implement single-ended to differential, single-ended input, and double-ended output. Has high performance, low noise, wide power supply voltage range and other advantages..
  • The THS413x consists of a true fully differential signal path from input to output. This design produced excellent common-mode noise suppression wells that improved total harmonic distortion..
  • Chip features High performance 150 MHz - 3 dB bandwidth (VCC = ±15V) 51V/us slew rate -100dB third harmonic distortion (250kHz) 2. Low noise 1.3 nV/vHz Input Reference Noise Differential input/cent output Balanced Output Suppresses Common Mode Noise Reduce second harmonic distortion from dry differential output.
  • Wide supply voltage range VCC-5 V Single Supply to ±15V Dual Supply ICC (SD) = 860 u A Shutdown Mode (THS4130) Chip application Single-ended to differential conversion Differential ADC Driver Differential antialiasing Differential transmitters and receivers Output Level Translator.
Check Stock

Juried Engineering TL072CP IC Dual Low-Noise JFET-Input Operational Amplifier & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 10)

  • The TL072 JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low-input bias and offset currents, and low offset-voltage temperature coefficient..
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock