Best Amorphous Current Transformer

ACEIRMC 8pcs HX711 Weighing Sensor Dual-Channel 24 Bit Precision A/D Module Pressure Sensor for Arduino Raspberry Pi Microcontroller

Analog Current Meter Module. Transformer can only sense AC.
This electricity sensor is based on TA12-100 current transformer, which can transform AC signals of large current into small amplitude signals..
3-wire electronic block interface, input 5V - GND. S pin is the output analog voltage value..
You can use jumpers to select the parallel output of the output to adjust the range of analog values that are output..
On-board 3P and 4P connecting interface for current signal output can be easily connected with your MCU development board.

Check Stock

AC Current Sensor Transformer, PZCT-02 Split Core Current Transformer Coil Sensor for 100A Amp Energy Meter Used for Energy Meter in Special,Current Sensors

❤Specification❤Opening size: 13mm × 13mm.
lead length: 1.5 meters, standard Φ3.5 three-pin plug outpu.
❤Applications❤Suitable for current measuring, monitoring and protection of AC motors, lighting equipment, air compressors, etc..
❤Reliability❤Fully compatible with most similar products.
the number of opening and closing times is not less than 1000 (tested at 20℃).
this split core current transformer is particularly suitable which can use for a long time for DIY use and it works well with arduino and raspberry pi..
Non-linearity ± 3% (10% ~ 120% rated input current) two output forms of current and voltage (voltage output type built-in sampling resistor)..
Package Include 2Pcs x SCT-013-000 Split Core Current Transformer Sensor.

Check Stock

PEACEFAIR PZCT-02 Split Core Current Transformer Coil Sensor for 100A Amp Energy Meter

SMALL AND LIGHT: This current transformer Built-in input coil.
SNAP JOINT STRUCTURE:The diameter of inner hole is 16mm, the accuracy is 0.5 grade, Using snap joint structure, it can be fixed to the cable directly through nylon ties..
GOOD MECHANICAL PROPERTIES: Fully enclosed, good mechanical properties and environmental resistance, strong voltage isolation capability, safety and reliability..
USED FOR ENERGY METER IN SPECIAL: Current transducer used for energy meter in special.
AC 220v, 380v power supply can both be applied..
MINI SIZE:This is a mini split base current transformer.
it's the smallest one compared to the similar products (output 100MA)..

Check Stock

OWON Current Clamp Meter Multimeter CP-05+ Clamp Current Probe 200KHz 400A for Oscilloscope 4A 40A 200A 200-400A Test Range with BNC Connector

¡¾High Performance¡¿The current clamp can take accurate current readings .The current clamps are the ideal tools to extend the current ranges of Oscilloscope tools.Support Auto zero at power on, relative zero correction function.It has Band wide up to 200KHz,support low battery indication .Adopt of amorphous alloy core, with high performance, low loss ..
¡¾BNC connector¡¿The current clamp Multimeter features a BNC connector and can be plugged directly use. After connected well, switch the current clamp on (power LED should light) and then clamp the jaws around the current carrying conductor as shown. Typical Uses The AC/DC Current Probe simply offers the best value for money without compromising resolution..
¡¾Multiple Test Ranges¡¿The OWON CP-05+ current clamp is ideal for use with automotive oscilloscopes for measuring currents between 1 mA and 400 A. Various current test range, 4A, 40A, 200A, 200-400A test range are available.Low noise level, and high detection accuracy..
¡¾Easy to Use¡¿The current clamp has range selection settings, set by a slider switch on the handle of the probe. In use there is no need to break into the circuit or disturb the isolation as the opening jaws simply clamp around the current carrying conductor. No ele....

Check Stock

Beleeb 20Amp Variable Transformer Auto AC Voltage Regulator Power Supply, 2000VA Max, 0~130 Volt Output

a variable AC input to a transformer input DC bridge rectifier to produce a variable output.
The adjustable voltage transformers does not convert AC to DC. It requires an AC input and the output is also AC. Also, the unit will not affect the cycle rate from the power company. If your power system is providing 60Hz, the Variac auto transformer will not change that, the ouput will be an undistorted 60Hz. This unit is rated up to 20 Amps or 2KVA Peak (16A Continous)..
Power: 2000VA,Input voltage: 110V, Input current: 18A, Output voltage: 0-130V, Rated output current: 15.38A (Continuous operation for 2 hours, 003c10A can work continuously.
This variable transformer is the perfect speed controller. The speed is infinitely variable, and because a transformer doesn't chop up the AC waveform like electronic speed controllers do, there's no noise, humming, etc..
If you're planning on using this as an "industrial" or bench-top supply with heavy loads, I'd recommend examining the brushes and adjusting the spring pressure on the windings. This can improve performance by reducing brush-contact sparking. Otherwise, this device is ready to work right out of the box..

Check Stock

Doorbell Transformer, 16.7 ft Charging Cable 18V 500mA Video Doorbell Power Supply Adapter Compatible with Ring Doorbell/Zmodo Doorbell (Black)

【Product Features】18V Doorbell Transformer, plugs into your standard 110 v/120 v outlet and converts to 18 volt 500 ma AC current. No more need to take your doorbell down to charge. Video doorbell Transformer can keep your device constantly powered..
【Compatibility】18V 500mA Doorbell Transformer compatile with Zmodo smart greet wifi doorbell / Nest Hello doorbell.(Before purchasing, Please confirm that the voltage and current required by the doorbell are consistent with this power supply.).
【Extra long cable】16.7ft is long enough, it can connect to your doorbell perfectly, don't worry about the distance between the socket and the doorbell..
【Easy to install】(Regardless of positive or negative polarity).Simply attach the two rings to the doorbell and tighten the screws. The wire ring design makes it easier to install and helps ensure the Transformer is firmly connected to the doorbell. The wires are sturdy and flexible enough not to be easily torn..
【After-sale service】: If you are not completely satisfied with our products, you can ask for a replacement or a full refund.If you have any questions, please feel free to contact us..

Check Stock

Leviton 1K240-2W Series 1000 120/240V 200A 1P3W Indoor Kit with 2 Split Core CTs

Electricity tariff support 4 decimals, the decimal point can be set to 0 between 4. It supports 3 charges: simple tariff, time-sharing tariff and stage tariff. Time-sharing tariff support 8 time periods to calculate the cost, which can be used for peak and valley billing. Stage tariff support 8 stages power rates. You can set the date that begin to charge the stage billing.
It has the function of alarm, you can set values for voltage, current, or power. If they were exceeded, the monitor will alarm automatically.
It has the function of clearing the total electricity, history data and factory reset.
It supports 1000:1 or 2000:1 current transformer, the max current of the transformer is 120A.

Check Stock

Gomadic Double Wall AC Home Charger Suitable for The Vivitar Camelio - Charge up to 2 Devices at The Same time with TipExchange Technology

Gomadic TipExchange Technology protects your investment by providing a means to change or upgrade your charger by simply swapping the physical....
A full 10W of available charging current (e.g. 2,000mAh) is available for rapid charging. Considerably higher available current compared to standard....
Custom designed advanced circuit provides precision output voltage and current regulation specific to the Vivitar Camelio (accurate to 0.1v). The....
Specification: Input Voltage (100 - 240vAC), Cable length (50 inches), Transformer Dimensions (2.0 X 1.75 inches), Foldable Adapter (Yes), Circuit....
One of a kind transformer is compact with foldable wall adapter, small, lightweight and highly portable. Will save space in both travel bag and wall....

Check Stock

AEMC JM861 AC Current Probe with BNC Connection and 6.5' Coaxial Cable, 1A to 9000A Range, 0.1mV/A Output

Band wide up to 100KHz, low battery indication.
Low noise level, and high detection accuracy.
Various current test range, 4A, 40A, 200A, 200-400A test range are available.
Adopt of amorphous alloy core, with high performance, low loss.

Check Stock