Best Usb To Serial Converter Chip

DTECH FTDI USB to TTL Serial 3.3V Adapter Cable TX RX Signal 3 Pin 0.1 inch Pitch Female Socket FT232RL Chip Windows 11 10 8 7 Linux MAC OS 6ft Black

  • 6 ft USB to TTL serial adapter (with 3 pin 0.1” pitch female header socket) connects devices with 3.3 V logic level UART signals interface to a....
  • A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet FTDI USB to TTL serial cable (3 way output flying leads ) provides access to UART (transmit) Tx, (receive) Rx and GND.
  • FTDI chipset on the PCB board has configurable internal EEPROM and 3.3V UART signals can be individually inverted by configuring the EEPROM.
  • 3V3 TTL to USB converter cord is compatible with Windows 11, 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, Mac OS, Linux 2.4 and greater.
Check Stock

DTECH USB to TTL Serial 3.3V Adapter Cable TX RX Signal 4 Pin 0.1 inch Pitch Female Socket PL2303 Prolific Chip Windows 10 8 7 XP Vista (6ft, Black)

  • 6 ft USB to TTL serial adapter (with 4 pin 0.1” pitch female header socket) connects devices with 3.3 V logic level UART signals interface to a laptop via USB port.
  • A genuine PL2303TA chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet USB to TTL serial cable 3V3 (4 way output flying leads ) provides access to UART (transmit) Tx, (receive) Rx, VCC (5V) and GND.
  • PL2303 Prolific chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM.
  • 4 pin 3.3V USB to TTL converter cord Compatible with Windows 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE.
  • ideal USB 2.0 debug cord for Vendor ID re-write, router, GPS, set top box, transmitter, flash firmware on hard drive, etc..
Check Stock

DTECH FTDI USB to TTL Serial 5V Adapter Cable 6 Pin 0.1 inch Pitch Female Socket Header UART IC FT232RL Chip Windows 10 8 7 Linux MAC OS 6ft Black

  • 6 ft FT232 USB to TTL serial adapter (with 6 pin 0.1” pitch female socket header) connects devices with 5V logic level UART signals interface to a....
  • A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet FTDI USB to TTL serial cable (6 way outputs, Single-In-Line ) provides access to Tx, Rx, RTS#, CTS#, VCC (5v) and GND.
  • FTDI chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM.
  • 6 pin header 5V TTL to USB converter cord is compatible with Windows 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, Mac OS, Linux 2.4 and greater.
Check Stock

SainSmart USB 4 Channel Relay Automation (5V)

  • NOYITO 2-Channel Micro USB Relay Module is equipped with a stable USB to serial port chip and a microcontroller. It can use the serial port debugging software to send serial commands on the computer to control the opening and closing of the 2-channel relay..
  • Onboard high performance microcontroller chip, CH340 USB control chip.With power LED indicator and relay status LED.On-board 2-channel 5V, 10A/250VAC, 10A/30VDC relay, long relay life, can work 100,000 times continuously..
  • Module with overcurrent protection and relay diode freewheel protection..
  • NOYITO 8-Channel Micro USB Relay Module ASIN：B09RGTSHHW.
  • NOYITO 4-Channel Micro USB Relay Module ASIN：B09RGVQXXT.
Check Stock

DTECH FTDI USB to TTL Serial 3.3V Adapter Cable 6 Pin 0.1 inch Pitch Female Socket Header UART IC FT232RL Chip Windows 11 10 8 7 Linux 6ft Black

  • 6 ft FT232 USB to TTL serial adapter 3.3V (with 6 pin 0.1” pitch female socket header) connects devices with 3.3 V logic level UART signals....
  • A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet FTDI USB to TTL serial cable 3V3 (6 way outputs) provides access to Tx, Rx, RTS#, CTS#, VCC (5v) and GND (power line provides 5V and data....
  • FTDI chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM.
  • 6 pin header USB TTL UART converter cord is compatible with Windows 11, 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, MacOS, Linux 2.4 and greater.
Check Stock

SparkFun ESP8266 Thing - Dev Board - WiFi-enabled microcontroller compatible with Arduino for Internet of Things WiFi Development On-board FTDI USB-to-Serial converter PCB trace antenna U.FL connector

  • All module pins broken out for ease of use. On-board FTDI USB-to-Serial. +19.5dBm output power in 802.11b mode.
  • 802.11 b/g/n. Wi-Fi Direct (P2P), soft-AP. Integrated TCP/IP protocol stack.
  • Integrated TR switch, balun, LNA, power amplifier and matching network. Integrated PLLs, regulators, DCXO and power management units.
  • Integrated low power 32-bit CPU could be used as application processor.
  • The USB-to-serial converter means you don't need any peripheral components to program the chip. Simply plug in a micro USB cable..
Check Stock

StarTech.com 1 Port USB to Serial RS232 Adapter - Prolific PL-2303 - USB to DB9 Serial Adapter Cable - RS232 Serial Converter (ICUSB232V2)

  • MAXIMIZED PORTABILITY: This USB to serial RS232 adapter converts a USB port into an RS232 DB9 serial port to connect to, monitor, and control a serial device.
  • BROAD COMPATIBILITY: Compatible with your USB 1.0 or 2.0 ports, this USB to RS232 converter works with your Windows, Mac or Linux system.
  • FAST TRANSFER SPEEDS: Experience fast speeds with this USB to DB9 serial adapter, supporting a Baud Rate up to 921.6Kbps.
  • PORTABLE DESIGN: Powered by a USB port, this USB to RS232 serial adapter cable features a lightweight design that conveniently fits into your carrying case, making it ideal for professionals on the go.
  • Install in almost any laptop or desktop computer through broad operating system compatibility, including Windows 8.
  • Communicate efficiently with connected devices with high-speed 921Kbps support.
  • Portable and lightweight, the USB-Powered design requires no additional power adapter.
  • USB to Straight-Through RS232 DB9 Serial Adapter.
  • Compatible with Windows 8, Mac OS X and Linux.
  • USB-powered - no external power adapter required.
Check Stock

TECHTOO 4 Port Professional FTDI CHIP USB to Serial RS232 DB9 Adapter Converter Serial Cable 9-Pin Male to Male with Thumbscrews

  • HOW IT WORKS: TECHTOO USB to Quad Port RS232 DB9 Serial Adapter is Designed for Connecting to Serial Devices Such As DB9 Equipped Serial Modems, ISDN Terminal Adapters, Digital Cameras, Label Writers, Palm PCs, Barcode Scanners, PDAs etc Through USB port with 1Mbps Data Transfer Rate.
  • CONNECTORS: With Standard USB Type A Male to Standard 9-pin DB9 RS-232 Serial MALE Connector with Hexnuts.
  • CONDUCTOR & SHIELDING: Tinned Copper Conductor and Triple Shielding Ensure the Best Data Transfer Rate. Powered by USB Port, No External Power Adapter Required. Simple Installation, Plug & Play after One Time Driver Installation ( Product come with a Driver CD ).
  • CHIPSET & SUPPORTED OS: FTDI FTDI232RL Chipset for Widest Possible Stablity and Compatibility with Windows (10/8.1/8/7XP), Mac, Linux, etc. Support Almost All Serial COM Port.
  • 12 Month WARRANTY: USB 2.0 to Serial (9-Pin) DB-9 RS-232 Converter Cable is Backed with 12 Month Warranty and Customer Service Support.
Check Stock

ACEIRMC ESP32-CAM WiFi + Bluetooth Module WiFi ESP32 CAM Development Board with Camera Module OV2640 2MP + FT232RL FTDI USB to TTL Serial Converter + 20 pin Jumper Wire

  • ESP32-CAM WiFi + Bluetooth Module WiFi ESP32 CAM Development Board with Camera Module OV2640 2MPcompatible for Arduino, Support Image WiFi Upload and TF Card.
  • Bluetooth: Bluetooth 4.2 BR/EDR and BLE standard.
  • Camera WiFi + Bluetooth Module 4M PSRAM Dual-core 32-bit CPU Development Board with OV2640 2MP Camera Module + FT232RL FTDI USB to TTL Serial Converter + 20 pin Jumper Wire.
  • FTDI USB Serial Adapter comes with the FT232RL chip and uses both 3.3V and 5V operating voltage. Adapter Logic-level can be set via jumpers on the board, which makes simple to connect to your controller. USB power has over current protection, using 500MA self-restore fuse..
  • This module supports interfaces such as UART / SPI / I2C / PWM / ADC / DAC.
Check Stock