Best Ttl Module

Development Board Module Kit Fit for 850/900/1800/1900 MHz GPRS/GSM Antenna, 5~26V

• Computer debugging USB--TTL. This module is powered by: 5V-26V, 5V 2A power supply is recommended. After plugging in the motherboard, the power supply must be able to supply 2A. The reason is that the GPRS Shield startup current and the maximum top current required to work up to 2A, but the USB port can not provide such a large current, so the external power supply equipment must be provided..
• The other power supply port leads to the 3.7--4.5V power supply for lithium battery power supply. The serial port is perfectly compatible. The TTL serial port is compatible with 3.3 and 5V microcontrollers..
• Make sure your SIM card is not locked. The best baud rate for GPRS Shield communication is 19200 BPS 8-n-1 (GPRS Shield automatically matches baud rate by default). Quad-Band 850 / 900/ 1800 / 1900 MHz - would work on GSM networks in all countries across the world..

ACEIRMC 4pcs AT-09 Bluetooth 4.0 Transceiver BLE Module Serial Port CC2541 HM-10 MLT-BT05

• The AT-09 is a module that contains a BLE chip (CC2541)..
• This small size Bluetooth 4.0 TTL transceiver module allows your target device communicate with for iPhone/iPAD, IOS 6 or Android 4.3 above devices..
• This module allows to perform serial communication with the BLE chip thanks to an Rx and a Tx pin..
• When the Bluetooth connection is not established, the baud rate, name, and pairing password can be set by the AT command. After the setting, the parameter is saved after power-off, and the Bluetooth connection automatically switches to the transparent transmission mode..
• The module is also very similar to the HM-10 module and is also compatible with it so if you have some experience with the latter, you will get started quickly with the AT-09..

HiLetgo 2pcs CP2102 MICRO USB to UART TTL Module 6 Pin Serial Converter STC Replace FT232

Painless Performance 80132 Single Pole, Double Throw Relay, 40 Amp

• ★ The 8-channel relay module is equipped with transistors, diodes and optocouplers to switch higher loads safely, reliably and with little power. The module is also equipped with generously dimensioned relays in order to be able to reliably carry out many switching processes..
• ★ 5V 8-channel relay module, each relay requires 70mA for switching (switching capacity AC: max. 250V / 10A.
• ★ 5V 8-channel relay module can be controlled directly with a microcontroller Raspberry Pi, Arduin, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic, etc..
• ★ The relay acts as a switch that responds to a signal from the Arduin. Because of this, it is widely used in IoT projects to control lights and other electronic devices..
• ★ Application: MCU control, PLC control, industrial area, smart home.If you need this relay, you can buy it directly. If there is a problem during use, you can contact us at any time to refund or replace it..

DC Variable Power Supply WZ5005 Adjustable Switching Power Supply with 4 Digit LCD Display for Lab Equipment and Electronic Testing

• ...DC power supply is made of flame retardant material with small size and light weight, possess constant voltage and constant current output, overvoltage and overcurrent protection, overtemperature and undervoltage protection for long time usage..
• EASY OPERATION-- USB to TTL module (U2T)/RS485 to TTL module (T485) can be selected with remote connection control for necessary test requirements..
• EQUIPPED WITH LARGE LCD DISPLAY-- Adjustable switching power supply is designed with 1.8-inch high-definition LCD screen with LCD 4-digit display, support PC upper computer, support for Android APP..
• DATA HOLD FUNCTION FOR EASY DATA STORAGE-- Variable power supply comes with convenient and quick data storage, key lock function to prevent misoperation..
• AUTOMATICALLY SHUT OFF FOR SAFE TESTING-- The output over?voltage (OVP)/over?current (OCP) data can be set through the buttons on the panel, and the over?temperature protection (OTP)/under?voltage protection (LVP) is built?in. When the output voltage, current and device temperature exceed the protection value, input voltage is less than the prote....

2Pcs HC-06 RS232 4 Pin Wireless Bluetooth Serial Transceiver Module Bi-Directional Serial Support Slave and Master Mode

• Industrial serial port bluetooth, Drop-in replacement for wired serial connections, transparent usage. You can use it simply for a serial port....
• Operating voltage: 3.3V(Note:SPP-CA Bluetooth module serial port level to 3.3V, if connect 5V level,the system needs to increase the level conversion....
• Small size, low power consumption,high sensitivity for send and receive.
• Allows your device to both send or receive the TTL data via Bluetooth....
• Defaults: Salve, baud rate 9600, Bluetooth name HC-06, pairing password 1234, LED status light on.Core module uses HC-06, leads from the module....
• Applications: The Bluetooth module is mainly used for short-range data wireless transmission,such as Bluetooth wireless data transmission,Industrial....

CGOLDENWALL Lab Compact Spin Coater Machine Spin Processor EZ4 + Oil-free vacuum pump + VACUUM SPIN CHUCK HS-EZ4

• ...DC power supply is made of flame retardant material with small size and light weight, possess constant voltage and constant current output, overvoltage and overcurrent protection, overtemperature and undervoltage protection for long time usage..
• EASY OPERATION-- USB to TTL module (U2T)/RS485 to TTL module (T485) can be selected with remote connection control for necessary test requirements..
• EQUIPPED WITH LARGE LCD DISPLAY-- Adjustable switching power supply is designed with 1.8-inch high-definition LCD screen with LCD 4-digit display, support PC upper computer, support for Android APP..
• DATA HOLD FUNCTION FOR EASY DATA STORAGE-- Variable power supply comes with convenient and quick data storage, key lock function to prevent misoperation..
• AUTOMATICALLY SHUT OFF FOR SAFE TESTING-- The output over?voltage (OVP)/over?current (OCP) data can be set through the buttons on the panel, and the over?temperature protection (OTP)/under?voltage protection (LVP) is built?in. When the output voltage, current and device temperature exceed the protection value, input voltage is less than the prote....

Flashpoint XPLOR 600 HSS TTL Battery-Powered Monolight with Built-in R2 2.4GHz Radio Remote System - Bowens Mount (AD600 TTL) with R2 Pro Transmitter for Nikon

• Godox AD600B TTL 2.4 GHz radio transmission (compatible with Canon E-TTL II, Nikon i-TTL, Sony, Olympus, Panasonic, and Fujifilm) Functions: Slave, off 5 groups, 32 channels.
• Maximum Watt/Seconds 600 Ws, Guide Number 285' / 87 m at ISO 100 with AD-R6/R7 reflector,.
• Recycle Time 0.01-2.5 sec, Flash Duration 1/220-1/10,000 sec, Color Temperature 5600K (±200K),.
• Fully support High-speed sync (up to 1/8000 seconds), first-curtain sync, and second-curtain sync. Optical and Built-in 2.4G wireless transmission to offer stable output. 80M Wireless Control with precision. 11.1V/8700mAh large capacity lithium battery pack to provide 500 full power flashes and recycle in 0.01-2.5 second. DC/AC are both applicable(Change to AC alternating current module after lithium battery pack detached). 10W LED modeling lamp can adjust light brightness in three steps. Large.
• INCLUDES: Flashpoint Godox Wistro AD600B TTL Battery Powered Monolight with Bowens Mount, Flashpoint/Godox X1Pro Transmitter, Battery Charger for AD600, Flash Tube, Lithium-ion Battery, AC Power Cord, Plastic Protective Cover, Custom Case, 2-Year Warranty.

Taidacent SIM800L GPRS GSM Module Micro SIM Card Core Board GSM Quad Band TTL Serial Port ESP32 ESP8266 SIM800L

• SIM800L GPRS GSM module micro SIM core board quad-band TTL serial port is ESP8266 ESP32.