Best Tension Assemblies

LMR-400/LMR400 Times Microwave Low Loss Coaxial Cable - PL259 UHF Male to UHF Male Connectors 50 Feet-CB Ham Radio Antenna - Made in The USA by Cable Assemblies Now

  • All Cable Assemblies Now Inc cable assemblies are MADE IN THE USA - we pride ourselves in making sure we provide all of our customers with the best quality product made with the highest quality materials.
  • WARRANTY on ALL Cable Assemblies made and mfg by Cable Assemblies Now Inc. have a limited 10 year warranty - Please do not hesitate to contact us for any questions or concerns.
  • We can guarantee that any cable under 1000MHz will have a Standing wave ratio plot of 1.25:1 at any frequency under 1000 MHz - We can also test return loss, insertion loss, phase angle, and use a Vector Network Analyzer to measure for both match and resonance..
Check Stock

iJDMTOY (2 Universal Sealed Rubber Housing Caps Compatible With Headlight Install Xenon Headlight Kit, LED Headlights Bulbs, Aftermarket Headlamp Retrofit, etc

  • This listing is for (2) universal sealed rubber housing caps.
  • Good for xenon LED conversion kits, aftermarket LED headlights, retrofit headlights, and many more of your retrofit lighting assemblies.
  • Seals your aftermarket retrofit LED assemblies and protects them from water condensation, moisture, dust, and other unwanted substances.
Check Stock

OTC 5285 1,650 lb. Capacity Air/Hydraulic Power Train Lift

  • OTC's 1,650 lb. capacity Powertrain Lift is perfect for handling engine and transmission assemblies, gas tanks, drive axle assemblies, engine/transaxle assemblies, electric vehicle batteries, and more.
  • Scissors-type design allows access to all 4 sides of a component for supreme accessability.
  • Two independent adjusting screws tilt the table 15 degrees side-to-side, or fore and aft and can be operated manually or with a non-impact air wrench.
  • Air/hydraulic operation via a foot control pump that features a flexible hose allowing movement around lift.
  • Features a 20 x 32 inch table, 8-inch high capacity swivel casters, a minimum height of 31-1/2 inches with a 74-1/2 inch maximum height, and a footprint that is 33 inches wide x 48 inches long.
Check Stock

Aftermarket Replacement 4 Pc Set Halogen Headlights & Signal Marker Lamps Compatible with 1999-2007 Sierra Pickup Truck Replaces 15199560 15199561 15850351 15850352

  • Good for xenon headlight conversion kits, aftermarket LED headlights, retrofit headlights, and many more of your retrofit lighting assemblies.
  • Seals your aftermarket retrofit LED assemblies and protects them from water condensation, moisture, dust, and other unwanted substances.
  • Made with high quality flexible rubber (+/- 3mm accommodation) that is ideal for retrofit lighting assemblies.
  • This listing is for 2 pieces of 95mm on the outer diameter size: To select the size of the cap you need, measure the outer diameter of your....
Check Stock

2-Pack AR-PRO 6” x 1.5” Flat Free Solid Rubber Wheel Assemblies - Replacement Hand Truck Wheels with Ball Bearings and 1/2” Bore Hole Diameter - Heavy-Duty Solid Rubber Wheels 132 lbs Load Capacity

  • AR-PRO 6” X 1.5” FLAT FREE SOLID RUBBER WHEEL ASSEMBLIES - These sets of flat-free wheel assemblies have nominal dimensions of 6 inches (outer....
  • REPLACEMENT HAND TRUCK WHEELS WITH BALL BEARINGS AND 0.5” BOREHOLE DIAMETER - These wheel assemblies come in different sizes, but these 6-inch tires....
  • HEAVY-DUTY SOLID RUBBER WHEELS WITH 132 LBS LOAD CAPACITY - Convenient and maintenance-free, these flat-free solid rubber tires and wheel assemblies....
  • HEAVY-DUTY SOLID RUBBER WHEELS WITH 132 LBS LOAD CAPACITY - The solid metal rims and hubs also have high resistance to impact cracks, making it highly....
  • SAFE AND COMFORTABLE RIDE - Say goodbye flats without saying goodbye to a smooth and comfortable ride. AR-PRO flat-free tires provide convenience,....
Check Stock

Huouo Heavy Duty Flagpole Beaded Retainer Rings to Keep Flag Close to Pole - for 7 Inch or 8 Inch Diameter Flag Pole White

  • This flag pole rings length from end to end is approx 36 inches, Used for 7" to 8" butt diameter flagpole, Which also can works as flag counterweights, help to aids in lowering flag in halyard systems.
  • Flag pole Retainer Ring are made with nylon beads of 1 in. diameter, nylon balls strung onto stainless steel aircraft cable, Each end is looped around a stainless steel ythimble and secured with an aluminum or copper crimp, Complete with stainless steel spring hook quick links to secure the loops together.
  • Flagpole Beaded Retainer Ring are used to secure the bottom of the flag as close to the flagpole as possible on Internal Halyard Systems as an aid to raise and lower the flag.
  • Reducing tension on the flag grommets, which can help lengthen your flag's life, To hold flag against pole so It doesn't get damaged in high winds.
  • Additional retainer ring assemblies are recommended for use with larger flags with multiple grommets, larger Internal & External Halyard flagpoles, flags flown in higher wind areas and when flying multiple flags.
Check Stock

iJDMTOY (2 95mm Rubber Housing Seal Caps Compatible With Headlight Install Xenon Headlight Kit, Aftermarket Headlamp or Retrofit

  • Good for xenon headlight conversion kits, aftermarket LED headlights, retrofit headlights, and many more of your retrofit lighting assemblies.
  • Seals your aftermarket retrofit LED assemblies and protects them from water condensation, moisture, dust, and other unwanted substances.
  • Made with high quality flexible rubber (+/- 3mm accommodation) that is ideal for retrofit lighting assemblies.
  • This listing is for 2 pieces of 95mm on the outer diameter size: To select the size of the cap you need, measure the outer diameter of your headlight's rear flange. If you're under by 3mm of the cap size, we recommend going for the next size down.
Check Stock

Burris Xtreme Tactical XTR II 5-25x50mm Precision Rifle Scope with 5X Zoom and Zero Click Stop Adjustment, Illuminated SCR Mil Reticle, Black

  • Designed for serious, technical, long-range precision rifle shooters.
  • Excellent resolution optics and competition-ready reticles and adjustment knobs make it easier to identify targets and adjust for windage and elevation.
  • Versatile 5x zoom system allows for a larger field of view at close ranges and better target acquisition at long ranges.
  • Ergonomic side focus and easy-to-reach parallax adjustment from 50 yards to infinity for improved accuracy at long distances.
  • Zero Click Stop adjustment knobs for quickly and easily reverting back to the original yardage setting without counting clicks.
  • Advanced windage and elevation adjustments for accurate and repeatable reticle adjustments.
  • High-grade optical glass provides excellent brightness and clarity with lasting durability.
  • Precision-gauged and hand-fitted internal assemblies maintain a consistent point of impact through the magnification range, regardless of shock and vibration.
  • Scope is waterproof and the nitrogen-filled body tubes prevent internal fogging in the cold and rain.
  • Triple internal spring-tension system allows the scope to hold zero through shock, recoil, and vibrations.
Check Stock

New Stens Pneumatic Wheel Assembly 175-763 for Woods 19703

  • AR-PRO 4.10/3.50-4” SOLID PU Run-Flat TIRE AND WHEEL ASSEMBLIES - These tire and wheel assemblies are the perfect replacement parts for wheeled equipment with wheels that have an outer diameter of around 10 inches, rim diameter of 4 inches, and tire width of 4.10 inches..
  • 10” FLAT FREE TUBELESS TIRES AND WHEELS FOR UTILITY EQUIPMENT - Highly compatible with yard tractors, wagons, wheelbarrows, hand trucks, portable generators, dollies, trolleys, lawn mowers, and more! Convert now to more efficient and maintenance-free tire and wheel assemblies!.
  • 5/8” AXLE BOREHOLE, OFFSET HUB, AND DOUBLE-SEALED BALL BEARINGS - Don’t let the thought of replacing an entire wheel assembly deter you from enjoying the benefits of a flat-free and tubeless hand truck wheel. The wheel assembly has an axle borehole inner diameter of 5/8 inch that will universally fit on 5/8-inch axles. There are two double-sealed ball bearings on each assembly to minimize rotational friction and provide both radial and axial load support..
  • HEAVY-DUTY SOLID PU TIRE AND WHEEL ASSEMBLIES - The layered 100% premium PU ensures that the rubber tires can perform excellently under heavy-duty applications. The solid and durable construction ensures that the tires are wear, puncture, tear, an....
Check Stock