Best Single Phase

Fielect Single Phase Diode Module Bridge Rectifier 60A 1200V for MDQ-60A Model 1Pcs

This Bridge Rectifier Warranty 1 years . If there are quality problems within 8 years, you can send us email. We will send you new ones ..
Model: MDQ-100A is designed for single phase Full wave rectification, which has four diodes connected in a one phase bridge configuration..
Max. Average Forward Rectified Current : 100A.
Production Size: 80 x 40 x 32mm/ 3.1" x 1.6" x 1.2" (L*W*T).

ATO 2 hp (1.5 kW) VFD, single phase 110V/120V input, 1 phase or 3 phase 220v-240v output, designed for driving single/three phase AC motor via 120v power supply.
【Voltage&Frequency】Input voltage: 1 phase 120V AC ±15%.
Output voltage: 1 phase or 3 phase 220V AC ±15%.
【APPLICATION】 ATO 110V VFD Can be widely applied to drive the AC motor, such as fans, pumps, power tools, etc..
【TIPS】 Choose a VFD base on motor rated current: VFD output current ≥ motor rated current.
【CUSTOMER FIRST】 If you have no experience in driving a VFD, be sure to refer to the instructions before operating a VFD.If you are not sure about the size or have any issue about the product or service, please don't hesitate to email us. We will answer you within 12h.

USED FOR-- High quality generator controller is integrated with digital, intelligent, and network technology for the automation and monitoring system of a single generator set.
MULTIFUNCTION-- Realize the automatic start/stop, data measurement, alarm protection and "three remote" functions of the generator set. Speed sensor frequency range: 1Hz-10KHz, speed sensor voltage range: 0.5V-70V.
WITH LARGE-SCREEN-- The controller adopts large-screen liquid crystal (LCD) display, Chinese, English, Spanish and Russian optional interface operation, simple operation and reliable operation.
WIDE APPLICATION-- Generator controller is suitable for 3?phase 4?wire, 3?phase 3?wire, single?phase 2?wire, 2?phase 3?wire (120V/240V) power supply 50Hz/60Hz system.
GOOD REPLACEMENT-- This generator controller module is a good replacement for your old or broken one, comes with 4pcs brackets, easy to install.

The AD8302 is a fully integrated system for measuring gain/loss and phase in numerous receive, transmit, and instrumentation applications. It requires few external components and a single supply of 2.7 V–5.5 V. The ac-coupled input signals can range from –60 dBm to 0 dBm in a 50 ohm system, from low frequencies up to 2.7 GHz. Both subsystems have an output bandwidth of 30 MHz, which may optionally be reduced by the addition of external filter capacitors. 003cbr003e.
The AD8302 can be used in controller mode to force the gain and phase of a signal chain toward predetermined setpoints.003cbr003e.
The AD8302 includes a phase detector of the multiplier type, but with precise phase balance driven by the fully limited signals appearing at the outputs of the two logarithmic amplifiers. Thus, the phase accuracy measurement is independent of signal level over a wide range. The signal inputs are single-ended, allowing them to be matched and connected directly to a directional coupler. Their input impedance is nominally 3 kΩ at low frequencies. 003cbr003e.
The phase and gain output voltages are simultaneously available at loadable ground referenced outputs over the standard output range of 0 V to 1.8 V. The output drivers can source or sink up to 8 mA. A load....

120/240V Single Phase Panel Mount Surge Protective Device, 4-Mode Protection, 50kA Max Surge Current Rating, NEMA 1 Enclosure, UL 1449 4th Edition....
Type 2 Single Phase Surge Panel with 4-Mode Protection.
Real-time diagnostic visual indicator shows power and suppression status for each protected phase.
Standard J-Box enclosure with pre-punched standard knock-outs can be easily surface mounted in typical frame construction.
Features a low VPR to ensure protection of sensitive electronic devices including LCD TVs and computers.

Initiation TechnologyTM: Used soon after birth can significantly increase breast milk production. INITIATE program contains a mixture of stimulation phases, an expression phase and a pause phase..
2-Phase Expression® technology: Can be used by all mothers to help build and maintain milk production. MAINTAIN program can be used to build upon initiation and maintain their milk production. Hospital grade (multi-user): The pump’s kit is separate from the pumping mechanism and protected from overflow by a specially designed membrane..
Convenient: Single or double pumping. Let-down button: Moms can easily return to stimulation by pressing the let-down button.
Two separate, independent membrane units: Allows switching between single and double pumping by simply applying or removing the second collection kit to the breast.
Initiate and maintain milk supply: If direct breastfeeding is not possible, as well as collect breastmilk at work or during other absences from the baby..