Best Serial Converter Module

SparkFun ESP8266 Thing - Dev Board - WiFi-enabled microcontroller compatible with Arduino for Internet of Things WiFi Development On-board FTDI USB-to-Serial converter PCB trace antenna U.FL connector

  • All module pins broken out for ease of use. On-board FTDI USB-to-Serial. +19.5dBm output power in 802.11b mode.
  • 802.11 b/g/n. Wi-Fi Direct (P2P), soft-AP. Integrated TCP/IP protocol stack.
  • Integrated TR switch, balun, LNA, power amplifier and matching network. Integrated PLLs, regulators, DCXO and power management units.
  • Integrated low power 32-bit CPU could be used as application processor.
  • The USB-to-serial converter means you don't need any peripheral components to program the chip. Simply plug in a micro USB cable..
Check Stock

DTECH FTDI USB to TTL Serial 5V Adapter Cable 6 Pin 0.1 inch Pitch Female Socket Header UART IC FT232RL Chip Windows 10 8 7 Linux MAC OS 6ft Black

  • 6 ft FT232 USB to TTL serial adapter (with 6 pin 0.1” pitch female socket header) connects devices with 5V logic level UART signals interface to a....
  • A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet FTDI USB to TTL serial cable (6 way outputs, Single-In-Line ) provides access to Tx, Rx, RTS#, CTS#, VCC (5v) and GND.
  • FTDI chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM.
  • 6 pin header 5V TTL to USB converter cord is compatible with Windows 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, Mac OS, Linux 2.4 and greater.
Check Stock

DTECH FTDI USB to TTL Serial 3.3V Adapter Cable 6 Pin 0.1 inch Pitch Female Socket Header UART IC FT232RL Chip Windows 11 10 8 7 Linux 6ft Black

  • 6 ft FT232 USB to TTL serial adapter 3.3V (with 6 pin 0.1” pitch female socket header) connects devices with 3.3 V logic level UART signals....
  • A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet FTDI USB to TTL serial cable 3V3 (6 way outputs) provides access to Tx, Rx, RTS#, CTS#, VCC (5v) and GND (power line provides 5V and data....
  • FTDI chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM.
  • 6 pin header USB TTL UART converter cord is compatible with Windows 11, 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, MacOS, Linux 2.4 and greater.
Check Stock

DTECH FTDI USB to TTL Serial 3.3V Adapter Cable TX RX Signal 3 Pin 0.1 inch Pitch Female Socket FT232RL Chip Windows 11 10 8 7 Linux MAC OS 6ft Black

  • 6 ft USB to TTL serial adapter (with 3 pin 0.1” pitch female header socket) connects devices with 3.3 V logic level UART signals interface to a....
  • A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet FTDI USB to TTL serial cable (3 way output flying leads ) provides access to UART (transmit) Tx, (receive) Rx and GND.
  • FTDI chipset on the PCB board has configurable internal EEPROM and 3.3V UART signals can be individually inverted by configuring the EEPROM.
  • 3V3 TTL to USB converter cord is compatible with Windows 11, 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, Mac OS, Linux 2.4 and greater.
Check Stock

12V to 5V Direct Current Converter Buck Module USB Output Power Adapter Direct Current Power Adapter Converter Regulator Car Power Converter (3)

  • Parameter: these usb buck module input voltage range DC 12V and output voltage default DC 5V, the maximum output current is 3A, no-load current is 10mA and the maximum output power will reach 15W.
  • USB and high conversion: this DC to DC converter module has USB charging ports, DC to DC buck converter has integrated switch thin regulator module, the conversion rate is as high as 96%.
  • Intelligent protection: this 12V to 5V DC converter is using intelligent microprocessing chip, over voltage, over current, over temperature and short circuit, it can be auto protection.
  • Wide application: DC converter module 12V to 5V is widely applied for GPS navigation, driving recorder, electronic dog, car radio, MP3, MP4, walkie talkie, surveillance system, bus display, taxi advertising screen, LCD TV, LED, etc..
  • Warm prompt: the power of devices must be lower than 15W when using this DC to DC converter 12V to 5V, and not compatible with partial Samsung phones.
Check Stock

12v to 5v Converter Buck Module USB Output Power Adapter Dc Power Adapter Converter Direct Current to Direct Current Regulator Car Power Converter (1)

  • Parameter: these usb buck module input voltage range DC 12V and output voltage default DC 5V, the maximum output current is 3A, no-load current is 10mA and the maximum output power will reach 15W.
  • USB and high conversion: this DC to DC converter module has USB charging ports, DC to DC buck converter has integrated switch thin regulator module, the conversion rate is as high as 96%.
  • Intelligent protection: this 12V to 5V DC converter is using intelligent microprocessing chip, over voltage, over current, over temperature and short circuit, it can be auto protection.
  • Wide application: DC converter module 12V to 5V is widely applied for GPS navigation, driving recorder, electronic dog, car radio, MP3, MP4, walkie talkie, surveillance system, bus display, taxi advertising screen, LCD TV, LED, etc..
  • Warm prompt: the power of devices must be lower than 15W when using this DC to DC converter 12V to 5V, and not compatible with partial Samsung phones.
Check Stock

DTECH USB to TTL Serial 3.3V Adapter Cable TX RX Signal 4 Pin 0.1 inch Pitch Female Socket PL2303 Prolific Chip Windows 10 8 7 XP Vista (6ft, Black)

  • 6 ft USB to TTL serial adapter (with 4 pin 0.1” pitch female header socket) connects devices with 3.3 V logic level UART signals interface to a laptop via USB port.
  • A genuine PL2303TA chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet USB to TTL serial cable 3V3 (4 way output flying leads ) provides access to UART (transmit) Tx, (receive) Rx, VCC (5V) and GND.
  • PL2303 Prolific chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM.
  • 4 pin 3.3V USB to TTL converter cord Compatible with Windows 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE.
  • ideal USB 2.0 debug cord for Vendor ID re-write, router, GPS, set top box, transmitter, flash firmware on hard drive, etc..
Check Stock

2PCS DC-DC Boost Converter, DC-DC 3.3V-13V to +15V/-15V Positive Negative Dual Step-Up Converter Board

  • This boost converter module can convert DC 3.3V~13V to DC ±15V..
  • The boost converter module can output positive and negative voltages..
  • Working Frequency: 400kHz, and the power module is automatically raised and lowered..
  • The boost converter module can be widely used as power supply for for ADC, DAC, LCD, and etc..
  • Maximum Input Current: 1.8A, Maximum Output Current: +Vo 600mA,-Vo 120mA, Quiescent Current: 3-4mA.
Check Stock

StarTech.com 1 Port RS232 to Ethernet IP Converter / Device Server - Aluminum - Serial over IP Device Server - Serial to IP Converter (NETRS2321P)

  • ACCESS YOUR SERIAL DEVICES REMOTELY: Use this RS232 to Ethernet IP converter to connect to, configure and remotely manage an RS232 serial device over an IP network.
  • DURABLE CONSTRUCTION: Built with a rugged aluminum housing, this serial to IP Ethernet device server delivers a reliable performance that can be used in almost any environment.
  • FLEXIBLE INSTALLATION: This serial to IP converter can be mounted to a surface or on a DIN rail with the built-in mounting bracket and included DIN rail clips.
  • Access a serial device from anywhere with an IP-based connection.
  • Mount on DIN-rails or on a wall with the attached mounting brackets.
  • Suitable for hash environments with a rugged, aluminum enclosure.
  • Configure via web browser or Virtual Com software interface.
  • Support for DHCP, HTTP, ICMP, ARP, IP, UDP, TCP.
Check Stock