Best Rule 25d Bilge Pump

attwood Sahara MK2 800 GPH 12-Volt Automatic Bilge Pump

800 GPH, 12V, Fuse size: 4A, Outlet type: 3/4" & 1" barbs, Check valve: yes, Wire length: 29 1/2".
The easiest, most reliable automatic bilge pump ever designed.
The only automatic bilge pump that eliminates air-locks, Patented X-Air Impeller ejects trapped air in the pump and pipework.
Flexible Outlets: 90° rotatable elbow outlet allows users to install the pump anywhere in a full 360° orientation.
Single-Hand Pump Cartridge Release: Convenient when trying to access a pump located in a hard-to-reach area of the boat’s hull.
Universal Backwards Compatible Design: 7-pump mounting hole pattern for replacing any top bilge pump in its category.
SteadySwitch: Buoyancy control reduces cycling, draining the bilge not the battery.
No Pipe Or Hose Removal Required: Reduces the time that it takes to replace the cartridge.
Improved Motor Cooling/Heat Dissipation: Prevents overheating that may cause failures, such as blown fuse, leaking, etc..
Includes straight outlet and check valve.

Check Stock

Johnson Pumps - 22102 PROLINE Bilge Pump 1000 GPH 2.5A

No one wants to worry that their boat is slowly taking on water because the bilge pump has failed. Well, you can sleep soundly with the reliable 2000 bilge pump on the job.Small size, high efficiency, low current (low cost switching power supply supporting).
to achieve a small size perfect combination of high flow..
It is non-automatic and must be paired with a float switch or sensor and ON/OFF/AUTO switch. Unique automatic "discharge" function can bear the long-term continuous operation under nearly congestion condition Impact resistant ABS housing.
Used in a boat,you can also use it in solar powered waterfall for your backyard, in a battery back-up sump system,etc. It empties the bilge roughly 25% faster than 1500gph bilge pump,and will continue to pump even when it encounters some minor debris.
Heavy duty motors with stainless steel shafts and tough. thermoplastic bodies submersible bilge pumps are tough enough for any bilge.Tough, efficient, long life motor.Offer high capacity output Water cooled long-life motors.
Ignition protection Water/moisture tight seals.
Snap lock strainer base for easy installation and removal.

Check Stock

LINGVUM Bilge Pump for Kayak Canoe and Boat - 17 Inch Manual Portable Kayak Hand Water Pumps with Reversible Hose Orange

CONVENIENT BILGE MANUAL WATER PUMP --- Our manual bilge pump length is 16.5", the maximum unfolded length is 25.5", equipped with a 23.2"long hose. At the same time, Our bilge pump has two water inlets and a long hose that attaches to either end, removing water quickly and reducing your fatigue.
MAKES WATER REMOVAL EASIER --- The maximum displacement is 0.4L each time. The premium rubber seal creates a watertight seal that won't come loose or leak allowing for the maximum amount of suction and discharge that performs better than other hand bilge pumps. Suction spacers can allow water to flow into the manual water pump at the fastest speed.
SCENE TO BE USED --- Perfect for emergency water removal in boats, kayaks, canoes or dinghies. With our kayak bilge pump, rest easy knowing that you’ll have a quick and easy way of removing water in those difficult times. Spending time on the water is supposed to be fun! Perfect boating and kayaking accessory.
LIGHTWEIGHT & PORTABLE --- This kayak hand pump is light (Only 0.78 pounds), easy to carry and store. Foam padded handgrip is non-slip and provides buoyanc....

Check Stock

Boat Marine Manual Hand Bilge Waste Water Transfer Pump Qiilu Plastic Handle Marine Manual Diaphragm Hand Bilge Water Pump for Boat Yacht

Excellent Design------Boat Marine Manual Hand Bilge Waste Water Transfer Pump is suitable for compact manual self-priming pump. Provides flow rates up to 12 gallons per minute (45 liters per minute)..
Durable and Reliable------Boat Marine Manual Hand Bilge Waste Water Transfer Pump has a robust and durable construction designed for marine applications. Ideal as a backup bilge pump in case your electronic bilge pump fails..
Specifications------ Manual Diaphragm Pump, Material: ABS, Diaphragm Manual Pump with Two Position Handle, Packing List: 1 x Manual Diaphragm Pump, 2 Adapters, 2 Seals..
Dimensions ------- Hose Inlet: Approx. OD. 1.36" (34.5 mm), Hose Outlet: Approx. OD. 1.36" (34.5mm), Max Suction Lift: Approx. 10ft (3m), Max Discharge Head: 13ft (4m). Flow: 720GPH (2724 LPH).
Easy to use------fixed handle with rubber handle, easy to use. Installation can be done without complicated steps..

Check Stock

SeaChoice 19301 Submersible 2000 GPH Bilge Pump

【Specification】：Outlet Diameter : 29mm/ 0.95 Inch (1-1/8") POWER：1100 GPH Current(A）：3.2A Volt：12V.
【Automatic mode connection】：Connect black wire to negative,Connect brown wire to positive,the pump will be shut off automatically when the water is pumped out.This auto bilge pump 1100 gph would improve work efficiency and could be used for a long term..
【Advantages】:Equipped with built in electronic controlled sensor system for easy fully automatic operation.It is a small automatic boat bilge pump and it is rustproof and corrosion resistant..
【Warning】:This auto boat bilge pump is designed for use with fresh water and salt water only. And polarity is important. If it is not correct, the pump rotate backwards..
【Applications】:Ideal For Fishing Boats, Cruisers, Runabouts, Yachts, skiff, etc..

Check Stock

Five Oceans Bilge Pump Three-Way Rocker Control Panel Switch with Circuit Breaker, Black, Automatic-Manual-OFF functions, LED light indicator, FO-3851

With this Three Way Bilge Pump Switch, you do not have to change a fuse. In case of having a short circuit, just press the button of the circuit breaker to restore the circuit.
PROVIDE remote control of automatic bilge pumps or bilge pumps with float switches.
3-WAY Stylish Rocker Switch has Auto, OFF and Manual positions. Power indicator light confirms system power.
MANUAL position has spring back feature to prevent bilge pump from continuously running.
COMPATIBLE with bilge pumps that draw up to 10A - 12/24VDC. FIVE OCEANS, 40 YEARS developing High-Quality Marine & Outdoor Products.

Check Stock

attwood Sahara MK2 500 GPH 12-Volt Automatic Bilge Pump

500 GPH, 12V, Fuse size: 3A, Outlet type: 3/4" & 1" barbs, Check valve: yes, Wire length: 29 1/2".
The easiest, most reliable automatic bilge pump ever designed.
The only automatic bilge pump that eliminates air-locks, Patented X-Air Impeller ejects trapped air in the pump and pipework.
Flexible Outlets: 90° rotatable elbow outlet allows users to install the pump anywhere in a full 360° orientation.
Single-Hand Pump Cartridge Release: Convenient when trying to access a pump located in a hard-to-reach area of the boat’s hull.

Check Stock

Shoreline Marine Bilge Pump with Float Switch, 800 GPH

The pump securely clips into the mounting base for easy installation and for removal to clean and inspect the pump.
The self-contained automatic switch will detect water and automatically turn the pump on, when the water is gone shut the pump off.
The automatic bilge pump is completely submersible with a water pumping capacity of 800 GPH.
The ¾” O.D. outlet hose barb is designed to be used with standard ¾” I.D. bilge hose.
It’s ignition protected, uses a very low 5 amps operating current the wires are tinned marine grade.

Check Stock

Newport Kayak Hand Bilge Pump, Blue

DUAL ACTION: Our Kayak Hand Bilge Pump is dual action, meaning whether you're pushing or pulling, it's still pumping water out of your boat..
FLOATING: If you drop it overboard, this pump will float back up to the surface for you..
EJECTION TUBE: Our pump includes an ejection tube, so the water you pump doesn't end up back in your boat..
WHY: Quickly pump water out of the floor of your kayak, canoe, jon boat, inflatable dinghy, sailing dinghy, or other small watercraft. Use the ejection hose to clear the hull so the water isn't ending up back in your boat..
INCLUDED IN BOX: Kayak Bilge Pump w/ Foam Float, Water ejection tube.

Check Stock