Best Rf Spectrum Analyzer

Bingfu SMA Male to UHF SO239 Female & PL259 Male RG58 Coaxial Jumper Cable 12 inch 30cm (2-Pack) for Portable VNA Vector Network Analyzer Antenna Analyzer Spectrum Analyzer SWR Meter Tester

Compatible with: Antenna Adapter Cable for Ham Radio, Amateur Radio, Handheld Floating Marine VHF Radio, Two Way Radio, Walkie Talkie, USB RTL SDR Receiver.
Compatible with: Test Probe Coaxial Jumper Cable for Handheld RF Explorer, SWR Meter, VNA Vector Network Analyzer, Antenna Analyzer, Spectrum Analyzer.
Package List: 2 x Cable (As the Picture Shown).

Connector: UHF SO239 Female 50 Ohm Connector.
Compatible with: Antenna Adapter Cable for Ham Radio, Amateur Radio, Handheld Floating Marine VHF Radio, Two Way Radio, Walkie Talkie, USB RTL SDR Receiver.
Compatible with: Test Probe Coaxial Jumper Cable for Handheld RF Explorer, SWR Meter, VNA Vector Network Analyzer, Antenna Analyzer, Spectrum Analyzer.
Package List: 1 x Cable (As the Picture Shown).

With the new spectrum analysis function added to the OpenTX firmware, it is now possible to check the airwaves for RF noise..
Communication ProtocolACCST D16 /ACCESS Feel Free to Choose.
Haptic vibration alerts and voice speech outputs.
Supports spectrum analyzer function Supports SWR indicator warning.

Multiple high sensitivity sensors installed for detecting Power line, Smart meter, Cell phone, Microwave etc..
Identify/recognize the common possible sources, such as Power line, Cell Tower, Microwave, Static etc..
Safety suggestion lets you understand current situation instantly..
Detects 5G network signal and RF up to 10Ghz.
Built-in RF Spectrum analyzer and GQ RF Browser for real time RF monitoring..

[2022 Upgraded Version: ESD Protection Diodes] Produced by Hugen, portable spectrum analyzer with latest firmware V0.3.1, the displayed version info is "ESD protected" meaning the diodes are installed which will be more stable and sensitive with higher antistatic level and longer service life. NOTE: Due to the old inventory might mix with the new batch, and If you got the old version Tiny spectrum analyzer and want a new one, you could apply a replacement for it..
[Frequency Range] Spectrum analyzers like the Tiny spectrum analyzer use a resolution filter that is used to isolate the input power in a small frequency range. This resolution filter is swept across the desired frequency range. The fastest scanning speed occurs with an RBW or 300kHz or wider and is about 2 scans per second. But with increase of the frequency span and decrease of the RBW the scanning speed decreases quickly. A scan from 0MHz to 350MHz with an RBW of 10kHz takes about 2 minutes..
[2 in 1 Device] When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz. Built-in calibration signal generator that is used for automatic self test and low input calibration. The Tiny spectru....

【With Two Inputs】Spectrum analyzer with two inputs, fine quality MF/HF/VHF input for 0.1MHz-350MHz, lesser quality UHF input for 240MHz-960MHz. Switchable resolution bandpass filters for both ranges between 2.6KHz and 640KHz..
【MF/HF/VHF Input】Input step attenuator from 0dB to 31dB for the MF/HF/VHF input. Color display showing 290 scan points covering up to the full low or high frequency range..
【Portable and Convenient】Rechargeable battery allowing a minimum of at least 2 hours portable use. Connected to a PC via USB it becomes a PC controlled spectrum analyzer..
【Wide Application】When not used as spectrum analyzer it can be used as signal generator, MF/HF/VHF sinus output between 0.1MHz-350MHz, UHF square wave output between 240MHz-960MHz..
【Package Included】1 * Spectrum Analyzer.

✅【2023 Upgraded TinySA Ultra】:This New Version V0.4.5.1 Spectrum Analyzer is developed by Hugen, with 4.0 inch 480 x 320 large touchscreen display, 100kHz to 5.3GHz widely measure range, with the new ESD protection function, the product has a higher anti-static level and a longer service life, and built-in 32Gb micro SD card, can directly record data to the card ,which is convenient for your data sharing and storage..
✅【Frequency Range】:Compared to the tinysa (100kHz to 960MHz), the upgraded tinysa ULTRA has 100kHz to 5.3GHz ultra-wide measuring frequency range, spectrum analyzer for 0.1-800MHz, with Ultra mode up to 0.1MHz-6GHz.Switchable resolution band pass filters for both ranges between 200Hz to 850kHz. Color display showing 450 scan points covering up to the full low or high frequency range. Faster and more accurate measurement performance, you can easily cope with measurement testes in various fields..
✅【2 in 1 Multifunctional Frequency Analyzer & Signal Generator】:When not used as Spectrum Analyzer it can be used as Signal Generator,with sine wave output between 0.1-800MHz or square wave or dual tone output up to 4.4GHz.Built-in calibration signal generator that is used for automatic self test and low input calibration..

[ Accurately Track ] This portable spectrum analyzer 35‑4400MHz Equipped with a tracking source TG, the frequency of the signal output by the tracking source can accurately track the tuning frequency of the spectrum analyzer..
[Output Range]35MHz‑4.4GHz signal source output range, can display and analyze a simple spectrum.The input dBm scope is -80dBm~0dBm, output dBm is 0dBm..
[4 Major Modes ]Four major modes: Network mode, Spectrum mode, Point frequency mode, Sweep mode. After power on, the default mode is Network mode..
[3.5 Inch Touch Display ] Touch function, without button operation, you can directly click on the touch screen to operate..
[Portable ] Handheld spectrum analyzer Easy to carry and tiny , powered by USB-C cable,it can be easily hand‑held for measurement or carried to various places.Made of aluminum alloy material, wear resistance and can provide long service time..

Two-channel USB digital oscilloscope, spectrum analyzer, and network analyzer (±25V, differential, 14-bit, 100MS/s, 30MHz+ bandwidth).
Two-channel arbitrary function generator (±5V, 14-bit, 100MS/s, 12MHz+ bandwidth).
16-channel digital logic analyzer, pattern generator, and protocol analyzer (3.3V CMOS and 1.8V or 5V tolerant, 100MS/s).
Two input/output digital trigger signals for linking multiple instruments (3.3V CMOS).
Additional instruments including a data logger, impedance analyzer, and power supplies.