Best Rf Power Amplifier

AD831 High Frequency Transducer RF Mixer Module 500MHz Bandwidth Mixing Down Mixing Dual Balanced Mixer Single Chip Radio Frequency Converter -10dBm

  • The AD831 is a low distortion, wide dynamic range, single chip mixer, suitable for HF and VHF Receiver RF-IF frequency, second mixer in DMR base station, DC-baseband conversion, quadrature modulation and demodulation, and ultrasound imaging, frequency move detection and other applications.
  • The AD831 has provide +24 dBm third-order intermodulation intercept point, realization of -10 dBm LO power, without the need for a high power LO drive.
  • There is no corresponding shielding and isolation problems, therefore, compared with the passive mixer to improve the performance of the system, reduce the system cost.
  • The mixer is designed as a single power supply, RF, IF and LO ports with DC isolation capacitor, easy to use.
  • The amplifier has low DC offset characteristics, so it can be used in DC-baseband frequency conversion and quadrature amplitude demodulation.
Check Stock

4 Rockville WB65KLED 6.5\ 600w Metal Marine Wakeboard LED Tower Speakers+Amp+Mic

  • Package Includes: (2) Pair Rockville RKL65MBW 6.5" 700w Marine Boat Speakers w/LED+Black/White Grilles. (1) Rockville ATOM S20 Marine Bluetooth Amplifier 1600w 4 Channel/Volt Meter+PA Mic. (1) Rockville RMWK4 4 AWG Gauge Waterproof Marine Amplifier/Amp Install Wire Kit. (1) Rockville MRCA25 25 Foot Twisted Pair Marine RCA Cable 100% Copper, Split Pin.
  • Features of RKL65MBW: Pair Rockville RKL65MBW 6.5” 2-Way 700 Watt Marine Boat Speakers with LED Lights. CEA Compliant Power Ratings. Power Rating: 350 Watts Peak /85 Watts RMS Per Speaker. Total Power: 700 Watts. Beat sync LED’s flash to the rhythm of the music. You can select either red or blue color LED’s on the wire harness. No extra installation for the LED. It gets a power signal through your speaker wire..
  • Features of ATOM S20: Rockville ATOM S20 1600 Watt Peak/440 Watt Dyno-Certified RMS 4 Channel Class AB Marine Stereo Amplifier With Bluetooth. Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, RF faostgte etc). 2 Ohm: 110 Watts x 4 Channel 003c1% THD+N @ 14.4 Volts. 4 Ohm: 70 Watts x 4 Channel 003c1% THD+N @ 14.4 Volts. 4 Ohm Bridged: 220 Watts x 2 Channel 003c1% THD+N @ 14.4 Volts..
Check Stock

2902832, Frequency transducer, F Input: 0.002Hz-20kHz, Out: V/I, Screw Conn, Mini MCR-SL-F-UI-NC

  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler detection in imaging.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
Check Stock

Mixer Module, 0.1‑500MHz Conversion Board High Frequency Transducer -10dBm for HF VHF Receiver for Quadrature Modulation for Base Station

  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler detection in imaging.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
Check Stock

Professional RF Cable TV Signal Amplifier with High 40dB Gain

  • Professional-grade cable TV and antenna signal amplifier with high 40dB output level. Supports TV coax cable signal from cable outlet, cable TV box, antenna, DTV, CCTV DVR, MATV or all other RF modulated TV system. Designed for large multi-dwelling units(MDU) that require precise RF amplification with gain and slope adjustments for a professional installation..
  • High-power amplification to compensate for the attenuations of the passive TV distribution components like cable, taps, splitters and cable outlets. Advanced CATV hybrid circuitry providing extremely low-noise figure and minimum distortion. Adjustable gain control and tilt control allows for easy system balancing..
  • Solution in solving the problems of noise, interference and weakness after distribution. Boost RF coax signal with ease for more than 1700FT or 500m if RF TV source signal has fair 70/75dB strength to start with. Boosts the existing CATV or antenna signal strength for greater distance with minimum loss for more TV distribution..
  • Adjustable gain/attenuation to reduce overdriving. Adjustable tilt compensation to allow large CATV systems to be properly balanced and mixed with other CATV or existing RF distribution system. Supports full TV frequency range from 40MHz to 860MHz for analog/di....
Check Stock

Mixer Module, 0.1‑500MHz Low Distortion High Frequency Transducer -10dBm Conversion for Base Station for Quadrature Modulation for HF VHF Receiver

  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler detection in imaging.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
Check Stock

KICKER (2) 44L7S152 15" 4000 Watt Solobaric L7S Subwoofers+Amp+Sub Box+Wire Kit

  • Package Includes: (2) Kicker 15" Car Subwoofers. (1) RockvilIe Dual 15 MDF Solo Baric L7/L5/L3 Vented Subwoofer/Car Sub Box. (1) RockvilIe dB15 6000 Watt/3000w RMS Mono Class D 2 Ohm Car Audio Amplifier. (1)Engauge by Memphis KIT0 0 Gauge Amplifier Amp Installation Wire Kit 17 ft. RCAs. 20 Drywall Wood Screws (Wood screws are the type of screws.
  • the screws are actually made of metal). 20 Feet of 14 AWG Blue Speaker Wire. 4 Spade Terminals. Features:.
  • Kicker L7S152 15" 2000 Watt Solobaric L7S Car Subwoofer Solo-Baric 44L7S15-4. Dual Two-Ohm Voice Coils. Injection-Molded Polypropylene Cone. Patented Corner Ribs Minimize Distortion. SoloKon 360-Degree Back Bracing. Ribbed Santoprene Surround With Blue Surround Stitching. UniPlate Back Plate And Pole Piece, Plus Perimeter Venting For Excellent Thermal Management. Thick Tinsel Leads. Large Ceramic Magnet. Cast Aluminum Basket. Satin-Nickel Plated, Spring-Loaded Speaker Terminals.
  • The Solo-Baric L7S 15-Inch Subwoofer works best with a sealed or ported enclosure and 1,000 watts of recommended power. See below for more details. Specifications: Size: 15" (38.1 cm). Impedance: 2 Ohms DVC. Max Rec Amplifier Power: 2000 Watts Peak / 1000 Watts RMS. Sensitivity: 89.4 dB 1w/1m. Frequency Response: 18Hz - 100Hz. Moun....
Check Stock

High Frequency Transducer, Mixer Module 0.1‑500MHz Bandwidth Mixing for HF VHF Receiver for Quadrature Modulation for Base Station

  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler shift detection in imaging.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
Check Stock

Rockville Pair RKL65MBW 6.5" 700W Marine Boat Speakers W/Led+Black/White Grilles

  • Package Includes (2) Pair Rockville RKL65MBW 6.5" 700w Marine Boat Speakers w/LED+Black/White Grilles. (1) Rockville MS10LB 10" 2400 Watt Black Marine/Boat 10" Free Air Subwoofer with LED. (1) Rockville DBM50 4000 Watt/980w RMS 5 Channel Marine/Boat Amplifier Amp+Mic. (1) Rockville RMWK4 4 AWG Gauge Waterproof Marine Amplifier/Amp Install Wire Kit. (2) Rockville MRCA25 25 Foot Twisted Pair Marine RCA Cable 100% Copper, Split Pin.
  • Features of RKL65MBW: Pair Rockville RKL65MBW 6.5 2-Way 700 Watt Marine Boat Speakers with LED Lights. CEA Compliant Power Ratings. Power Rating: 350 Watts Peak /85 Watts RMS Per Speaker. Total Power: 700 Watts. Beat sync LEDs flash to the rhythm of the music. You can select either red or blue color LEDs on the wire harness. No extra installation for the LED. It gets a power signal through your speaker wire..
  • Features of MS10LB: Rockville MS10LB 10" Marine Free Air Subwoofer with LED (Black). Free air subwoofer does not require any enclosure. Max Power: 2400 Watts. RMS Power: 600 Watts. Polypropylene cone with Rubber edge. 2.0" 4 Layer dual voice coil. Molded ABS plastic basket made with a special blend that is wate....
Check Stock