Best Pwm Controller Board

200 Watt Folding Portable Solar Panel Kit Foldable Monocrystalline Suitcase Briefcase Set, 20A PWM Controller w/ LCD Screen, Generates 10.8 amp Power, Charges 12/24 Volt Battery

  • 200 WATT MAX POWER: This kit generates 10.2 amp power and can produce 600-1200Wh in a day, usable as charger for 24V battery. Features a maximum power voltage of 20.4V & a maximum system voltage of 1000VDC. The panel can operate from -40°F to 185°F.
  • FULL SOLAR STARTER KIT: Includes (1) 200W solar brief case, (1) 3 ft. cable w/ SAE to Anderson Connector, (1) 3ft. cable w/ SAE to DC 8055 Male Connector, (1) 10ft. cable w/ Bare Wire to Alligator connector, (1) 20A PWM Controller, and (1) carry bag.
  • UPGRADED 20A CONTROLLER: With a 20A PWM Controller on LCD Screen, it can intelligently detect devices and modify the appropriate current to prevent reverse polarity overcharging, short-circuiting, and reverse current in other electronic devices.
  • FOLDING BRIEFCASE MONOCRYSTALLINE PANEL: This solar panel has an unfolded dimension of 54.13" x 26.8" x 1.4" and a folded dimension of 36" x 26.2" x 2.36". Its approximate weight is 36.6 lbs. The folding panel is also dust tight & water resistant.
  • GREAT FOR TRAVEL & CAMPING: This solar panel board is perfect for any off-grid application & suited for applications that require a smaller footprint. Used for marine, dry camp, RVs, trailer, boat, shed, cabin, golf car, electric car, camper & more.
Check Stock

DC Motor Driver, DROK L298 Dual H Bridge Motor Speed Controller DC 6.5V-27V 7A PWM Motor Regulator Board 12V 24V Electric Motor Control Module Industrial 160W with Optocoupler Isolation

  • DROK DC motor driver input voltage range is DC 6.5V-27V, can be input DC 12V or 24V, rated output current of each port is 7A, total output power is 160W..
  • STRONG DRIVE: the motor controller board adopts dual H bridge, can drive two DC motors at the same time..
  • FORWARD and REVSERSELY ROTATE: the IN1, IN2/IN3, IN4 port can control forward or reverse motor rotation..
  • PWM SPEED CONTROL: enable signal terminal (ENA) input PWM can regulate speed, PWM frequency range 0-10KHZ..
  • UNDER VOLTAGE PROTECTION: the motor driver module is with under voltage protection to prevent instantaneous large current from damaging the module..
Check Stock

tatoko DC Motor Speed Controller 10V-55V 12V 24V 36V 40A Stepless DC Motor Speed Controller with Forward-Brake-Reverse Switch,Ajustable Potentiometer &Digital Display

  • Input supply voltage: DC 10V-55V；Maximum current: 60A； Continuous current: 40A.
  • Potentiometer with switch function,High power speed controller switch which is much more adaptable.
  • DC10V-55V PWM Brushed DC Motor Speed Controller Adjustable Driver CW CCW Reversible Switch With Digit Display.
  • Outer casing: it is designed to protect the controller board from damage as well as dissipate heat.
  • The input voltage must differentiate "+" ,"-.
Check Stock

WSDMAVIS 2Pcs PWM to Voltage Module 0% -100% PWM Converted to 0-10V Voltage Digital Analog Signal Converter for PLC Signal Interface Switching

  • The PWM transfer voltage module LC-LM358-PWM2V converts the PWM digital signals into 0 to 10V analog signals.Allowable error:5%..
  • It can be used as signal interface switching for PLC or other industrial control boards. The output voltage is regulated by adjusting the duty ratio of the PWM..
  • The modules are small in size and easy to use in different places.Easy to operate, fine tuned by potentiometer..
  • MCU embedded technology.Work Voltage:DC 12V-30V(Power requirements:> 100MA).
  • Select the PWM signal input level range through short-circuit.The peak of 4.5V to 10V level. The short cap install in ‘5V’. This level is used for normal controller or 5V MCU.
  • The peak of 12V to 24V level, so inserted in 24V. The short cap install in ‘24V’. This level is used for normal PLC controller..
Check Stock

CHANCS Mini Electric Motor 775 DC 12V/24V With Drill Chuck and PWM DC Motor Speed Controller

  • This is a DIY combination of motor, bracket, B10 drill chuck，and 20A PWM speed controller, it can be used with a saw blade to become a mini saw..
  • 【The specification of motor:】 Rated Voltage: DC 12V, Unloaded Speed: 10000RPM, Load Speed: 8800RPM. Rated Voltage: DC 24V, Unloaded Speed: 20000RPM, Load Speed: 17600RPM. Starting current: 4-5A Motor Body Diameter: 42mm, Motor Body Length: 66.5mm, Shaft Length: 16mm, Shaft Diameter: 5mm..
  • 【The specification of bracket:】 Length: 50mm, Width: 52mm, Height: 53mm, Mounting hole diameter: 4mm, Thickness of bracket: 3mm..
  • 【The specification of the speed controller:】 Input Voltage: DC 10V-DC 60V (Ultra wide working voltage)； Output voltage: linear under load； Control Power: 0.01-1200W； Rated Current: 10A； Max Current: 20A (Long-term use of 10A, 450W or less, pay attention to keep the module free of heat dissipation conditions.)； PWM Duty Cycle: 0%-100%； PWM Frequency: 25Khz； Product Size(L x W x H): 77*45*28mm；.
  • 【Attention:】 1.About the PWM, please do not connect AC power directly(Such as:110V AC),the input volt of this controller should be DC 9V-60V,otherwise it will be burned out. 2.Make sure the positive and negative connections are correct before powering on the motor speed contro....
Check Stock

FlexSolar 60W Portable Waterproof Solar Panel Charger kit and FlexSolar 30A 12V/24V PWM Solar Charge Controller

  • 【Compatible with Mutiple Battery Types】 FlexSolar PWM Solar Charge Controller with 30A Rated Charge/Discharge Current is Compatible With 12V or 24V System and Suitable for Sealed Lead Seal, Gel,Flooded and Lithium battery..
  • 【Efficiency PWM Solar Charge Controller】FlexSolar Solar Charge Controller adopts advanced PWM Control Method and The Charging Conversion Efficiency is Up 75-80%..
  • MULTIPLE PORTS & OPTIMIZED CHARGING】-The voltage switchable USB2.0 port, QC3.0 port, DC port, and Type-C port are ready to charge smartphones, tablets, laptops, power stations, coolers, and more. An intelligent chip automatically identifies connected devices and adjusts output current to offer the fastest possible charging speed..
Check Stock

PC Interface Controller

  • 【One-year after-sale warranty】The PWM to voltage module converts PWM digital signals to 0 to 10V analog signals. It can be used to switch the signal interface of PLC or other industrial control board. Adjust the output voltage by adjusting the PWM duty cycle. The module is small in size and easy to apply in different places.003cbr003e.
  • Using MCU embedded technology. Easy to operate, can be fine-tuned by potentiometer.003cbr003e.
  • Select the PWM signal input level range by short circuit. The module is small, easy to carry and easy to use.003cbr003e.
  • (current greater than 100mA)，PWM signal receiving frequency range: 1KHZ-3KHZ.
  • When power on for the first time, it is best to do a calibration and debugging: find a signal with a 50% duty cycle and connect it to PWM and GND. Jumper caps set the corresponding voltage range. When the frequency is 1KHZ-3KHZ, use a multimeter to measure the two ports of VOUT and GND. At this time, the meter displays about 5V. Adjust the potentiometer on the board so that the multimeter displays 5.00v.003cbr003e.
Check Stock

Arctic F9 PWM PST - Value Pack (5pc) - Standard Low Noise PWM Controlled Case Fan with PST Feature

  • Innovative DESIGN enables quiet and efficient ventilation: The innovative design of the fan blades improves the air flow and facilitates a highly efficient ventilation. The impeller was designed with a focus on minimzing the noise level yet delivering the desired airflow and pressure. Air flow – 43 CFM. Noise level – 0.3 sone.
  • Perfect case fan regulation with PWM: the PWM function allows the motherboard to run the fan precisely at its necessary speed. This guarantees the required cooling and minimizes the noise level.
  • Pwm Sharing Technology (PST) lowers noise: The PST assures That all of your fans listen to one control signal. E.G. You share the CPU cooler’s PWM signal and assure that your case fans stand down at low load and spin up whenever necessary.
  • Long service life: The fluid Dynamic Bearing comes with an oil capsule that avoids lubricant leakage. Thus this bearing is as quiet as a sleeve bearing but comes with a significantly higher service life.
  • Fan controller Made in Germany: The Arctic F8 PWM PST fan is well known for high airflow at a comfortable noise level. The real improvement is the motor and controller. Our German engineers made this fan work at lower speed When performance is not needed.
Check Stock

BougeRV Solar Panel Starter Kit 200 Watt, 9BB Mono Cells with 30A 12V/24V PWM Negative Ground Solar Controller, Solar Cables, and Mounting Z-Brackets for Camping and Off-Grid (100W*2)

  • One Purchase For Your Project. Totally 200 watts system, a one-stop installation kit contains 2 pieces of 100-watt solar panels, 1 of 20FT/10AWG solar to controller cable, 1 pair of 14-10AWG M/FF and F/MM Y connectors, 1 pair of 8FT/10AWG controller to battery cable, and 1 set of 8 units mounting z brackets..
  • 1-on-1 Solar Solution by BougeRV Tech Support & Warranty. BougeRV promises an 18-month product warranty & 25-years power warranty and a lifelong friendly service for you. Please contact us whenever you have any problem with BougeRV solar panel. We will provide you with a professional guide to building a solar system..
  • 9BB Cell Design. More Busbar, More Power. BougeRV 100W solar panel uses the high-level 9BB cell design, which has a 22.8% highest conversion rate. Increase the receptive surface of the cell.
  • a narrower ribbon decreases the covered area by 22%. It can charge a 12V or 24/48V battery by connecting several solar panels in series..
  • Negative Ground PWM Controller. BougeRV new version PWM charge controller has a negative ground design, allowing it to be compatible with more vehicle systems without worryi....
Check Stock