Best Motor Ac Current

CHANCS Mini Electric Motor 775 DC 12V/24V With Drill Chuck and PWM DC Motor Speed Controller

• ...combination of motor, bracket, B10 drill chuck，and 20A PWM speed controller, it can be used with a saw blade to become a mini saw..
• 【The specification of motor:】 Rated Voltage: DC 12V, Unloaded Speed: 10000RPM, Load Speed: 8800RPM. Rated Voltage: DC 24V, Unloaded Speed: 20000RPM, Load Speed: 17600RPM. Starting current: 4-5A Motor Body Diameter: 42mm, Motor Body Length: 66.5mm, Shaft Length: 16mm, Shaft Diameter: 5mm..
• 【The specification of bracket:】 Length: 50mm, Width: 52mm, Height: 53mm, Mounting hole diameter: 4mm, Thickness of bracket: 3mm..
• 【The specification of the speed controller:】 Input Voltage: DC 10V-DC 60V (Ultra wide working voltage)； Output voltage: linear under load； Control Power: 0.01-1200W； Rated Current: 10A； Max Current: 20A (Long-term use of 10A, 450W or less, pay attention to keep the module free of heat dissipation conditions.)； PWM Duty Cycle: 0%-100%； PWM Frequency: 25Khz； Product Size(L x W x H): 77*45*28mm；.
• 【Attention:】 1.About the PWM, please do not connect AC power directly(Such as:110V AC),the input volt of this controller should be DC 9V-60V,otherwise it will be burned out. 2.Make sure the positive and negative connections are correct before powering on the motor speed controller, it will ....

AC Current Transmitter Walfront AC Current Transducer Overload Protector Input AC 0-200A Output DC 0-10V SZT20-CH-10V No Power Required

• ☛ CURRENT MONITORING -- Mutual inductance current monitoring has high current detection accuracy and safe isolation of input and output..
• ☛ MEASURE CURRENT RANGE -- Self-powered, no external power supply required. Measured current AC 0-100/150/200A, output signal DC 0-10V..
• ☛ STRAIGHT-THROUGH DESIGN -- Straight-through structure design, isolation withstand voltage up to 2000V. Straight-through wire diameter: 0.35-20mm..
• ☛ ABS OUTER CASTING -- Hysteresis is less than 1% and can be used under strong magnetic conditions. The outer casing is made of self-extinguishing material ABS..
• ☛ WIDE APPLICATION -- Suitable for AC current measurement and monitoring, AC motor overload protection, electronic switch of automatic control system and so on..

AC Current Transducer Transmitter Transformer Sensor AC Current Converter AC 0-50A to DC 0-5V SZT15-CH-5V

• Safe Security: Mutual inductance current monitoring has high current detection accuracy and safe isolation of input and output..
• Easy To Use: Easy to install and use, no need to connect DC into the circuit when measuring..
• Product Specification: Self-powered, no external power supply required. Measured current AC 0-10/20/50A, output signal DC 0-5V. Straight-through structure design, isolation withstand voltage up to 2000V..
• High Quality：The outer casing is made of self-extinguishing material ABS..
• Widely Application: Hysteresis is less than 1% and can be used under strong magnetic conditions. Suitable for AC current measurement and monitoring, AC motor overload protection, electronic switch of automatic control system and so on..

UEi DL599 - Wireless TRMS Clamp Meter with Motor Testing (600 A AC/DC)

CR Magnetics CR4411-5 Average RMS AC Current Transducer with Single Element, 20 Hz - 4 KHz, 003e= 2K Output Load, 24 VDC +/-10%, 0-5 AAC Input Range, 0 - 10 VDC Output Range

• CURRENT MONITORING --- Mutual inductance current monitoring has high current detection accuracy and safe isolation of input and output..
• STRAIGHT-THROUGH DESIGN --- Straight-through structure design, isolation withstand voltage up to 2000V. Straight-through wire diameter: 0.35-20mm..
• MEASURE CURRENT RANGE --- Self-powered, no external power supply required. Measured current AC 0-100/150/200A, output signal DC 0-10V..
• WIDE APPLICATION --- Suitable for AC current measurement and monitoring, AC motor overload protection, electronic switch of automatic control system and so on..
• ABS OUTER CASTING --- Hysteresis is less than 1% and can be used under strong magnetic conditions. The outer casing is made of self-extinguishing material ABS..

MEISHILE DC 12V 50A 600W Switch Power Supply 110V AC to DC 12 Volt 50 Amp SMPS Converter Power Supply Adapter Transformer

• ☆ Simultaneous power supplies for devices with different currents/watts. Transformer (PSU) convert AC to DC using SMPS mode. Used for DC 12V Servos, Pumps, Car stereos, LED light strip, CCTV security camera, household appliances, electronic devices, brushless motor, automation equipment, computer project, etc.
• ☆ Universal input voltage: AC 110V / 220V (85-145V/185-265V).
• Output current depends on the current drawn by your device. The total output current/power can not exceed 80% of the rated power of the power supply.
• ☆ Portable, Small and Compact: 21.5×11.5×5cm/8.5×4.5×2 inch, Net weight 0.8 kg. SATISFACTION GUARANTEE: For any question, do not hesitate to contact us, we offer you a satisfaction guaranteed.
• ☆ High EFC, Low-loss, Long Service Life: More than 6,000 hours of service life.
•  Low standby power consumption, High efficiency. EFC much higher than linear supply. Safe and Stable: Power Supply has over / under voltage, over heat protection, continuous fan heat dissipation. Strictly tested before leaving the factory..
• ☆ Choose: The Rated Power is the Peak Power, does not mean that it applies to devices at this power (watt). For resistive device, SMPS peak p....

PRINCE CASTLE Drive Motor Assembly 87-028AS

• ATO 110v vfd, single phase 110v/120v input, single phase or three phase 220v output, achieve to run 220v AC motor on single phase 110v/120v power supply.
• 【Voltage& Frequency】Input voltage: 1 phase 120V AC ±15%, Input frequency: 50Hz/60Hz,Output voltage: 1 phase or 3 phase 220V AC ±15%, Output frequency: 0.00~400.00Hz.
• 【APPLICATION】ATO 7.5 hp 5.5kW variable frequency drive Can be widely applied to drive the AC motor, such as fans, pumps, power tools, etc.
• 【TIPS】 To protect the variable frequency drive and Motor, you need an upstream protection, add a line-choke upstream the VFD, this will reduce the current transients seen by the input of the VFD.
• 【CUSTOMER FIRST】If you have no experience in driving a VFD, be sure to refer to the instructions before operating a VFD.If you are not sure about the size or have any issue about the product or service, please don't hesitate to email us. We will answer you within 12h.

SIEMENS 6ES7 214-1AG40-0xB0 SIMATIC S7-1200 CPU 1214C, Compact CPU

• Programmable Control -- This module is programmable control, can achieve thousands of functions, stable and reliable working performance, built-in watchdog timer circuit, to ensure that the module for a long time to run Input high speed pulse C235, C251 and FX1N compatible.Output relay 1A output, Rated current 5A, can directly drive DC solenoid valve, AC solenoid valve, AC contactor, AC motor, etc..
• Built-in Analog Input and Output -- Built-in Analog input AD, corresponding to internal data register D5030.(Not D8030) Built-in Analog output DA, corresponding to internal data register D5101..
• The PLC with Two Programming Port -- The TTL interface and the 232 interface. The 232 interface, you can directly use the USB-232 serial port with a computer to download the program directly. When the PLC need to connect with the touch screen or text, can be used to conne....

New Genuine PS for HP Z420 Workstation 600W Power Supply 632911-001 623193-001

• 24V Power Supply: Input AC 110V/220V, Output 24V, Rated power 24A 600W, PSU(SMPS) AC to DC convert , output current depends on the requirements of the power consuming equipment, Power multiple devices with different Currents/ Watts.
• Intelligent Cooling: 24V 600W Power Supply converter with aluminum alloy shell, built-in cooling fan, metal shell with multiple holes for more efficient cooling, more stable work, high efficiency.
• USED WIDELY：DC 24V Power converter Used for Brushless type motor drive, Amplifier,Radios,LED drive, CCTV Camera System, Car Stereos, water Pump and more 24V Device. NOTE:Not suitable for charging Battery,Speed Control Motors..
• Safe stable: long service life, power supply with over/under voltage, overheating protection,Compact:21.5×11.5×5cm/8.5×4.5×2 inch, weight 0.75 kg，SAFETY: Use must derating: max load cannot exceed 80%.
• Note: SMPS peak power is 25A 600W, avoid overload, For resistive equipment, Recommended for equipment under 20A 480W. For motor equipment, the starting current will be much higher than the rated power and the peak power of the SMPS needs to exceed 2 times the motor power..