Best Module Controller

Isolation Amplifiers Isolated Modulator (5 pieces)

  • ➤【DC12-32V】- This isolation module need two complete independent DC12-32V power supply..
  • ➤【Main function】- Main function is input 0-10V analog voltage signal,after isolation, output 0-10V analog voltage signal..
  • ➤【Scope of Application】- Used to isolate high voltage or strong interference voltage or current (voltage) signal then transferred to PLC or controller MCU, isolating controlling end and controlled end, to assure stability and anti-interference ability of system..
  • ➤【Use】- It will has better performance if install this module and controller in a metal box and box is grounded..
  • ➤【Note】- The potentiometer is used to amend corresponding relation of output voltage. Output voltage can be fine adjusted and calibrated, normally it has already been calibrated..
Check Stock

Dingdong Store DIY Electronics Kits Ultrasonic Module Distance Measuring Transducer Sensor 0~5.5m Soldering Project Kit for Car Reversing Alarm, A561

  • The main controller of this module is STC89C51/52 micro controller.
  • The digital tube displays the measured distance, and the triode drives the digital tube.
  • HC-SR04 ultrasonic module measuring distance, measuring range 0.02m~5.5m.
  • This module can be used as a car's reversing radar, and the alarm distance can be set and changed with keys..
  • Please read the User Manual before installing. Our policy is to make our customers happy. If you are not 100% satisfied, just contact our customer service, we will refund your money. Since your product is shipped by Amazon, we are not sure what happened to our product at Amazon's warehouse. If any components are missing, please contact us for replacements..
Check Stock

LANTRO JS 1.14 Inch TFT Color LCD Display Module ST7789 8Pin IPS 135x240 TFT Display Screen Module

  • The module is a low-power consumption character LCD Module with a built-in controller..
  • The module can be easily interfaced with a MCU..
  • Display Format: 20 Characters x 4 lines..
  • Fully assembled and tested Serial LCD 20x4 Module..
Check Stock

TEKONSHA 90885 / Tekonsha Prodigy P2 Electronic Brake Control f/1-4 Axle Trailers - Proportional

  • Ram 1500 2500 3500 4500 5500 Electronic Integrated Trailer Brake Controller Module with Switch. Part# 82215040AC, 82215040AB, 82215040, 68105206AC, 68105206AB.
  • Replacement for 2016-2021 Dodge Ram 1500.
  • Warranty for 12 Months! Adopt high-end chips to provide fast braking with positive response, and the performance is at least 50% higher than other similar parts..
  • Integrated Trailer Brake Control Module allows driver to automatically or manually activate the electronic brakes on properly equipped trailers for greater stopping power on downhill grades. The controller and status display are mounted in the dashboard to the left of the steering wheel, and the included control lever can activate the trailer brakes independent of the truck's brakes. Drivers can customize the amount of brake force the trailer uses, depending on load requirements..
  • It is necessary to check if the vehicle has both trailer brake module connectors. These connectors are located under left side of the steering column. Both connecters are 4 pin connectors. If both connecters are not present the ITBM kit cannot be added to the vehicle..
Check Stock

Nordic BLE 4.0 nRF51822 Controller Chip Bluetooth Module Small Size 18.5 x 9.1x 2.0mm 5 Pack

  • YTX51822-S01 is a high performance ,low power radio transmit and receive system module based on Nordic BLE 4.0 nRF51822 controller chips..
  • It has the smallest volume package in the industry, the size is 18.5 X 9.1X 2.0, suitable for most applications which pay more attention to the size..
  • The module integrate the complete standard low energy Bluetooth 4.0 protocol stack S110 drive..
  • Customer's MCU is connected to the module by UART port, it will automatically send a broadcast code after the module starts..
Check Stock

ElecGear 4X Replacement Joystick (EL2 FU 10K) for PS4 / PS3 Wireless Controller, Analog Stick Controller Sensor Assembly Thumbstick Module for Playstation

  • [EL2 FU 10K for PS4/PS3 Controller] – 4x replacement analog joystick was found in some PS4 DualShock 4 came with PlayStation 4 Pro, and some PS3 controllers also use this version. The thumbstick module was made by Favor Union (FU). The stick controller comes with 10KΩ trimmer potentiometers in orange.
  • [Compatibility] – The 14 prongs were positioned as the same as ALPS edition. Technically, the whole unit is interchangeable with EL1 ALPS 10K used in PS4 controllers, and other brands like ‘Scuf’ and ‘Razer Raiju Ultimate’ with ALPS joysticks inside. However, the trim pot resistor alone is not interchangeable with ALPS edition.
  • [Additional Resistor] – Complicated moving mechanism and daily wear and tear finally caused drifting. Even new sensors cannot be 100% balanced. Calibrating in controller settings might not work. We packed 10x correction resistors to solve the potential problem in hardware level. Solder one or two paralleled tiny resistors onto the potentiometer at the opposite direction against drifting. It will help correct 3 to 5 degrees drifting.
  • [When to replace] – The analog joystick needs to be replaced when your controller has the problem of drifting, creeping, stuttering, a blind spot, a dead spot, a dead zone, no react....
Check Stock

SainSmart Genmtisu CNC Router Machine Controller Board with ABS Case for CNC 1810-PRO/3018/3018-PRO

  • This controller board is designed for Genmitsu CNC Router 1810-PRO, 3018, and 3018-PRO. It can perfectly compatible with SainSmart Blue Laser Module..
  • Software: GRBL controller, UniversalGcodeSender..
  • Support XYZ three-axis control, spindle and laser module. Support 3 pin and 2 pin lasers (the 2 pin lasers: please connect the white interface " + s-")..
  • Support stepper motor: 12V, the maximum current within 2A, recommended within 1.5A and additional heat. (Any stepper motor 42, 57)..
Check Stock

5PCS HC-05 Wireless Bluetooth Receiver RF Serial Transceiver Module Master Slave Integrated Bluetooth Module 6 Pin Wireless Serial Port Communication BT Module

  • HC-05 Bluetooth Module is an easy to use Bluetooth SPP (Serial Port Protocol) module, designed for transparent wireless serial connection setup..
  • Default baud rate:9600, Button: Press the button.
  • the module enter the AT mode. AT commands are executed only in AT mode..
  • HC-05 is able to operate in both master and slave mode. Its communication is via serial communication which makes an easy way to interface with controller or PC. It's ideal replacement to your wired serial connection..
  • HC-05 Wireless BT Module: with this HC 05 Bluetooth module,You can quickly add the Bluetooth feature to your motherboard project, and then you can use your android phone to control some gadgets, such as: switch, LED..
  • Note: The module doesn’t suitable for IOS system..
Check Stock

Magnetic Game Controller Necklaces, Matching Necklace for Couples, Best Friend Necklace, Friendship Necklace (White+Gold)

  • Fully modular professional gamepad .Box Contents : 1 x ESWAP X PRO CONTROLLER gamepad, 2 x interchangeable mini-stick modules, 2 x interchangeable grip modules, 2 x interchangeable triggers, 1 x interchangeable four-direction D-pad module 2 x additional mini-stick caps, 1 x power cable, 1 x screwdriver for removing the modules, 1 x small storage bag for screwdriver and cable, Quick start guide and warranty information”.
  • New next-generation (NXG) mini-sticks: a longer lifespan, and greater precision.
  • T-MOD technology and Hot Swap feature lets you swap a module with any other — at any point in a game.
  • Extremely high-precision modules and action buttons, with minimal response times.
  • Box Contents : 1 x ESWAP X PRO CONTROLLER gamepad, 2 x interchangeable mini-stick modules, 2 x interchangeable grip modules, 2 x interchangeable triggers, 1 x interchangeable four-direction D-pad module 2 x additional mini-stick caps, 1 x power cable, 1 x screwdriver for removing the modules, 1 x small storage bag for screwdriver and cable, Quick start guide and warranty information”.
Check Stock