Best Lippert Trailer Jacks

FKG Trailer Bearing Kit for 3/4 Inch Straight Spindle, Set of 2

COMPATIBILITY — Designed to replace the 90-degree elbow fitting on your Level Up Hydraulic Leveling Systems — including Level Up Towable, Level Up Motorized and Lippert Motorized Hydraulic Leveling Systems.
EASY INSTALLATION — This is an exact replacement component — helping to streamline the installation process on your 5th wheel RV or travel trailer.
DESIGNED FOR YOUR RV — Our replacement fitting includes JIC-M to ORB-M adjustable ports and is 1/4" in diameter.
REPLACEMENT PART — At Lippert, we help you take the guesswork out of replacement parts with exact-match components designed to get your RV’s equipment up and running as usual.
IMPORTANT INFORMATION — Please reference your owner’s manual for detailed product installation and safety information before installation.

This durable manual scissor jack crank handle is easy to use and is also used for power tongue jacks in case of power failure..
Durable crank handle that will retract most Lippert landing gear and slide out assemblies..

Fits 1,250 to 8,000 lbs. capacity trailer axles.
Compatible with: Lippert, Dexter or Al-Ko trailer axle hubs with corresponding grease seal measurements.
Provides protective barrier between the axle hub grease and the outside elements.

Fits 1,250 to 8,000 lbs. capacity trailer axles.
Compatible with: Lippert, Dexter or Al-Ko trailer axle hubs with corresponding grease seal measurements.
Provides protective barrier between the axle hub grease and the outside elements.

Stabilize your Trailer in less than 60 Seconds. Made in USA System Stabilizes Parked Travel, Camper, or Fifth Wheel Trailer.
Trailer Must Have 4 Jacks, 2 front and 2 Rear for the system to be installed. Includes the two required Foot Plates plus two additional so all jack footplates will match..
Installs Permanently so there is nothing to setup or store. Approximately 2-3 hour install...
Works on both 5th Wheels and Travel Trailers with existing stabilizer jacks. If you have an Auto Leveling system Please check out our Item C..
Eliminates Need for Tripod. Between Wheel Chocks, and Slide Out Jacks.

3,500 lbs Idler Trailer Axle (Capacity 3.5K).
Internal Wiring System To ensure seamless design Protect brake wires from wear and tear.
Replaces TK Trailer Parts, AL-KO, Hayes, and Lippert Axles.
Underslung - Axle is welded with spring seats on the bottom Allows for lower ride height For optimal usage, use with double eye springs.
High Strength Straight Steel Axle Tube Construction to ensureA better highway experience.

M-PARTS ELECTRIC TRAILER BRAKES – Two Trailer Brake Drums 8 on 6.5” and two 12x2 Electric Brakes for 7000 lbs Axle with Hardware, Replaces Dexter and Lippert.
DIMENSIONS - 12” x 2” Trailer Brakes and 8 on 6.5” Brake Drums.
TRAILER BRAKE BOLT PATTERN - Mounting flange bolt pattern: 5-bolt (each brake).
HARDWARE - inner bearing, outer bearing, Grease seal, EZ Lube Dust cap, Lug nuts, Cotter Pin, Washers.
M-PARTS AUTO- M-Parts Auto specializes in trailer parts & accessories using the highest quality materials.