Best General Purpose Relay power Relay

IDEC RR3B-UDC24V MOMENTARY, 10A (Contact), Panel Mount, Power/Signal Relay, 24VDC (Coil), 1500MW (Coil), AC/DC Output, DC Input, 30VDC (Contact), 0.06A (Coil), 3PDT

  • Yuco double pole double throw contacts general purpose relay.
  • 110/120V ac capacity 30 amp 250vac /28vdc 2no/2nc.
Check Stock

uxcell 2 Pcs 4.7 Ohm 2 Pin Refrigerator Start Relay for Compressor Black

  • Total Size: 3.2 x 2.2 x 2.85cm / 1.26" x 0.87" x 1.12".
  • Pretty generic start relay used on various brands of mini fridges and coolers.
  • How to Select Relay : Shop relay, consistent of size,resistance and pin quantity as replacement.
  • Relay Breakdown Judgment : For start relay,shake it,with noise of debris collision,is broke..
Check Stock

Shuian 10 Pcs 3V Relay Power Switch Board, Songhe DC 1 Channel Optocoupler Relay, High Level Trigger for IOT ESP8266 Development Board.

  • The 3v Relay 1 Channel power switch module compatible with 10A 250VAC and 10A 30VDC load.4pcs * 2.5 mm Fixed Bolt Hole..
  • 3V/3.3V power relay module supports photocoupler isolation control and dual power supply input ensure high anti-interference ability. Fast response time less than 20ms and long life time up to 100,000 times snap action with diode freewheel protection..
  • Equiped with high-current relay, AC250V 10A.
  • DC30V 10A,each relay has normally open and normally closed contact. Can be selected by jumper relay and TTL or ground..
  • Support dual power supply input ensure high anti-interference ability,high reliability of photoelectric isolation protection,The external connection uses the rotary crimping terminal, causes the wiring to be more solid..
  • You are free to select whether the relay and the signal share the same power supply or not by removing the jumper caps on the pins or not. It is recommended to share the same power supply, because that is more convenient for using..
Check Stock

MACH3 Controller USB MACH3 100Khz Motion Controller Card Breakout Board Controller Card for CNC Engraving Servo Motor Stepper Motor Servo motor

  • 【Functions】The function of this motion control card includes that it supports automatic probe tool, emergency input, limit switch, and supports....
  • 【4-axis Linkage】Usb interface board supports for 4-axis linkage, you can connect four stepper motor drives or servo drives. 4 general-purpose....
  • 【Wide Use】The maximum step-pulse frequency of motion control card is100KHz, which is very suitable for CNC Engraving, Servo Motor, Stepper Motor....
  • 【Advantage】The motion controller needs using external 24V DC power to isolate USB and external port, and to make the system more stable. And it....
  • 【Drive Output Interface】The 4 general-purpose isolated relay drive output interface can drive four relays for controlling the spindle starts,....
Check Stock

AITRIP 8 Pack 3V 1 Channel Relay Power Switch Module with Optocoupler Opto Isolation High Level Trigger for IOT ESP8266 Development Board

  • 【30VDC 250VAC Load】 Equiped with high-current relay, AC250V 10A.
  • DC30V 10A, each relay has normally open and normally closed contact. Can be selected by jumper relay and TTL or ground..
  • 【High Level Trigger】The relay module is triggered by high level signal, which can be input from microcontroller IO..
  • 【 3V/3.3V power relay module】- This Relay Board provides a single relay that can be controlled by any 3V/3.3V digital input from your microcontroller IO..
  • 【Wide Application】- These 3v relay board works well with ARM /PIC /AVR /MCU/Raspberry/CNC machine/ PS4/3.3V /NodeMCU/ ESP8266 module etc..
  • 【Long Life】 - Fast response time less than 20ms and long lifetime up to 100,000 times snap action with diode freewheel protection..
Check Stock

Parts Express 12 VDC 4-Pin Relay Socket With Diode for Starter Kill Circuit

  • Never go beyond its capabilities. Try to stay 10 to 15% below what the rate is for.
  • 12-volt 5-prong relay. Excellent water-repellent and dustproof ability, but not using it in water.
  • Be careful when plugging the relay into the socket. If you push hard, you will bend the female connector.
  • Primary leads use 12 a.w.g tinned copper wire. Coil leads use 16 a.w.g.
  • SPDT relay: it has both normally open and normally closed terminals, terminal 87A is powered when the relay is inactive and switches the power to terminal 87 when the relay is activated.
Check Stock

788-304, Electromechanical Relay 24VDC 1.26KOhm 16A SPDT (15x86x53) mm Socket Switching Relay

  • Our Power Relay and Socket Base all through UL and CE certification.Product Name:subminiature Power Relay.
  • Contact Rating: 6A 250VAC / 30VDC, Construction: Plastic seaied..
  • Relay Model:HF41F/24-ZS , Relay Slim size (width 5mm), Outline size:28×5×15mm.
  • Socket Model: 41F-1Z-C2, Size : 70.9 x 88.3 x 6.3mm / 2.798"x3.48"x 0.25"(H*L*W).
  • Package Content : 3× Power Relay , 3× Socket Base, 1x Rail Slotted Aluminum , 2×Screw.
Check Stock

Wiring Harness,Eyourlife LED Light Bar Wiring Harness Kit 180W 12V 40A Fuse Relay On/Off Switch Relay 14AWG 12FT Length Heavy Duty Universal Fitment(2 Lead)

  • Eyourlife Switch Relay: Eyourlife IP56 waterproof power relay and blade fuse proctect circuit safety from overcurrent or short-circuit.Regulate the power to be consistent and prevent any surge..
  • 2 Available Leads:One wiring harmess with two light output connectors gives you brilliant solution to install dual Led lights..
  • Detail:Operating Voltage: 12V,Amp: 40A ,Power Relay Fuse: 40A ,Blade Fuse: ≤180W.
Check Stock

Relay Module One Way 30A Optocoupler Isolation Relay Module High Power Relay High/Low Level Trigger YYG-2(12VDC)

  • Our Power Relay and Socket Base all through UL and CE certification.Product Name:subminiature Power Relay.
  • Contact Rating: 6A 250VAC / 30VDC, Construction: Plastic seaied..
  • Relay Model:HF41F/24-ZS , Relay Slim size (width 5mm), Outline size:28×5×15mm.
  • Socket Model: 41F-1Z-C2, Size : 70.9 x 88.3 x 6.3mm / 2.798"x3.48"x 0.25"(H*L*W).
  • Package Content : 3× Power Relay , 3× Socket Base, 1x Rail Slotted Aluminum , 2×Screw.
Check Stock