Best Fixed Terminal

Goldwood TR10F 10' Single Truck Box Speaker Cabinet

  • Goldwood Sound TR10F single slim 10" woofer sealed car enclosure, 10" woofer hole is 9.125" in diameter, built-in terminal with gold screw posts, fits most cars.
  • High quality MDF hardwood, enclosure volume is .7 cubic feet, height 15" x length 19.25" x top depth 5.75" x bottom depth 7.375", speaker mounting depth is 5.125".
  • The front (where the woofer is loaded) is flat and the back is slanted, made of only the best black aviation carpet.
  • Ships fully assembled, simply drop in your woofer.
  • Use for car, truck, SUV or fixed installation speakers.
Check Stock

Kaunosta SMA Cable 6.5ft SMA Male to SMA Male RF Coaxial Extension Cable for Security System Antenna Input RG316 Wire Jumper

  • 【SMA jumper cable】RG316 male to male SMA extension cable.The connector housing and pin in center are made of pure brass to ensure a lower VSWR for higher transmission efficiency..
  • 【Character】RG316 SMA male to male coaxial cable with high temperature resistance, acid and alkali resistance, corrosion resistance, high frequency, low loss and low impedance, wide applicability. Compared to rg174 cables, rg316 cables have better performance in terms of signal attenuation and transmission delay..
  • 【Common applications】Used for SDR Dongle、FPV Drone、LTE hotspot etc.(such as:used on your FPV ground station to mount the antennas on the camera tripods.
  • This sma male extension cable is great if you are going to have a semi-permanent antenna mount in your car.).
  • 【Widely used】To extend the cord for the antenna included with the phone terminal, onvian fixed wireless terminal GSM gateway 850/900/1800/1900MHz wireless access platform pstn dialer LED etc..
  • 【Package】1 x RG316 sma male to sma male cable.The cable has a length of 2 meter(6ft), so the position of the connector can be adjusted appropriately according to the usage scenario..
Check Stock

Jamgoer 300A Bus Bar Heavy Duty Module Design Power Distribution Block 12V 24V 48V DC Busbar Box with 4X M8(5/16') Terminal Studs for Battery Marine Automotive RV Car Truck (Red)

  • →[Dimensions}: The bus bar is measured (L x W x H): 138 x 69 x 44.5mm (5.433"x2.72"x1.75"). Stud size: M8 (5/16")..
  • →[High Quality]: Bus Material: The battery distribution block is made of brass and nickel plated, which has good electric conduct performance and sturdy rust-resistant. The base is made of nylon - glass fiber reinforced to protect your safety, ensures great mechanical strength and durability..
  • →[Waterproof & Dustproof]: The power distribution block With four removable side plates, a insulated rear cover, that's designed to withstand rain and dust,resist the air and seawater erosion..
  • →[Unique Design]: The battery terminals base has non-slip sponge, increased Stability. And the blank write-on space on the top allows easy labeling for each branch..
  • →[Easy to Mount]: RV terminal blocks surface screw fixed installation, four mounting holes make this terminal block easier to be mounted in any orientation.Removable windows for unobstructed wiring..
Check Stock

Chanzon SPDT Mini Micro Slide Switch 1p2t 2 Position 70pcs 3mm Toggle Vertical Slide Switch Panel Mount Small High Knob Vertical for PCB Arduino Breadboard Electronic Board Dip Miniature SlideSwitch

  • MATERIAL – Plastic, Brass, Sliver Plated: Anti-corrosion and high conductivity.
  • Electrical Life: More than 100,000 click.
  • High Temperature Resistance: -13℉ ~ 176℉..
  • APPLICATION – Used For Arduino, Breadboard, Electronic Circuits, Electronics Board, Microphone, Audio, Video, Electric Circuit, Position Solder, Etc..
  • HOW DO TACTILE SWITCH WORK - The middle pin is fixed. When the handle is pushed to the left, the left two pins are connected, push it to the right, the two pins on the right connect, thus switching circuits..
  • Comes with on/off SPDT dip 3pin terminals 2 positions small long dual sliding switches..
Check Stock

Goldwood TR8F 8' Single Truck Box Speaker Cabinet

  • Goldwood Sound TR8F single slim 8" woofer sealed car enclosure, 8" woofer hole is 7.125" in diameter, built-in terminal with gold screw posts, wire leads included, fits most cars.
  • High quality MDF hardwood, enclosure volume is .4 cubic feet, height 11.25" x length 15.25" x top depth 5" x bottom depth 7.25", speaker mounting depth is 4.75".
  • The front (where the woofer is loaded) is slanted and the back is flat, made of only the best black aviation carpet.
  • Ships fully assembled, simply drop in your woofer.
  • Use for car, truck, SUV or fixed installation speakers.
Check Stock

Battery Jump Post Kit with Cable and Mounting Bracket Heavy Duty Remote Battery Charging Posts Battery Terminals Kit for UTV ATV Truck Car Trailer Boat

  • Remote Battery Terminals: The charging and jumper terminals kit is an extension connector for the vehicle's starting battery, which is directly connected to your starting battery and fixed in other places where the vehicle jumper is convenient.
  • Must-have Accessories: This battery jump post is compatible with all UTV/ATV models, and this item can also be used for trucks, race cars, travel trailers, RVs, tractors, lawn mowers , diesel vehicles, boats, etc..
  • More Convenient Charging: The cable adopts IP67 waterproof standard, and can withstand voltages up to 450V. 7 AWG cable for faster transmission. The remote battery jump post kit is in red and black as a whole for easy identification and prevents cables from crossing.
  • Reduced Size: The GUMRA battery charging posts kit has been improved on the basis of the original, with a smaller size and does not take up too much space to install. At the same time, install an insulating cap under the bracket to avoid exposure of metal fittings, making it safer to use.
  • Package Included: All accessories required for installation are included. Black PVC insulating bracket*1, pure copper terminal*2, 1.2m connecting wire*2, terminal insulating rubber cap*2, mounting screws*4.
Check Stock

5KW 6KW AVR Automatic Voltage Regulator Rectifier for Gasoline Generator W/Carbon Brush Honda GX390

  • Stop fluctuation of voltage, automatically maintaining generator output terminal voltage at a set value.
  • Prevent generator from suffering damages of voltage fluctuation or over load..
  • It uses an electromechanical mechanism, or passive or active electronic components..
  • According to the design, which is used to manage one or more AC or DC voltage..
  • In addition to the shunt regulator, the regulator operates through a number of fixed internal comparison of the actual output voltage of the reference voltage..
Check Stock

Glarks 580Pcs 2.8mm Pitch 2 3 4 6 9 Pin Wire Connectors Housing Terminal Male & Female Plug Housing and Pin Header Crimp Wire Terminals Connector Assortment Kit for Motorcycle Bike Car Boats

  • 【1】Product Type: High quality male & female plug housing and pin header crimp wire terminals connector assortment kit.
  • 【2】High Grade Material: As you can see, these connectors color are white, they are made of high quality insulation plastic, with tin-plated copper pin plugs, durable and wear resistance than normal products.
  • 【3】Package: In this kit, there are 2.8mm 2 3 4 6 9 pin male and female plug housing total 100pcs with 480pcs pin headers, assorted placed in a transparent plastic box for easy manage and store.
  • 【4】Feature: Connectors are designed with fixed hook makes it very convenient for your installation, just put the crimps in the tool and press them, make the crimp the insulation are all the way toward the wire,2.8 mm terminal for cable diameter up to 2.0 mm.
  • 【5】Application: These wire connectors housing terminal has a widely application in daily life, it can be used to connect internal wiring, and it is also widely used on cars, quad bike, tricycle, caravan, motorcycles, scooters, boat, snowmobile.
Check Stock

Sanford Brands 1756589 RHINO 5200 Label Printer Kit

  • GREAT FOR ASSET MANAGEMENT: Print Code 39 and Code 128 bar codes on 3/4" (19mm) wide labels.
  • INDUSTRY COMPLIANT: Meet key ANSI and TIA/EIA-606-A industry labeling standards.
  • TIME-SAVING FEATURES: Exclusive, one-touch “Hot Keys” to automatically size, space, and format label text for electrical and patch panels, terminal and 110 blocks, wire and cable flags, horizontal and vertical wraps, and fixed-length applications.
  • FAST LABELING: Labels up to 77% faster than the competition* *Based on independent testing of Rhino 5200 vs. Panduit PanTher LS8, Brady, BMP21, Brother PT1650 measured in number of key strokes when making patch panel labels and all associated wire and faceplate labels.
  • USE WITH AUTHENTIC DYMO LABELS: Uses DYMO Industrial labels.
  • includes 2 rolls of vinyl labels (3/4" & 3/8.
Check Stock