Best Fc Attenuator

Boealzhl 2W SMA DC-6GHz Coaxial Fixed Attenuators Frequency 6GHz SMA Fixed Connectors (20DB)

Useful in a wide variety of applications including impedance matching and level control..
With diffrent attenuation values of fixed attenuator to be chosen from. High quality, rugged construction..
Suitable for microwave equipment, electronic equipment or communication systems. The use of features frequency bandwidth, low standing wave, power, stable performance..
Coaxial Fixed Attenuator ONLY,other accessories demo in the picture is not included..

Useful in a wide variety of applications including impedance matching and level control..
With diffrent attenuation values of fixed attenuator to be chosen from. High quality, rugged construction..
Suitable for microwave equipment, electronic equipment or communication systems. The use of features frequency bandwidth, low standing wave, power, stable performance..
Coaxial Fixed Attenuator ONLY,other accessories demo in the picture is not included..

Useful in a wide variety of applications including impedance matching and level control..
With diffrent attenuation values of fixed attenuator to be chosen from. High quality, rugged construction..
Suitable for microwave equipment, electronic equipment or communication systems. The use of features frequency bandwidth, low standing wave, power, stable performance..
Coaxial Fixed Attenuator ONLY,other accessories demo in the picture is not included..

【IRF Tube】Using IRF series transmitting tube to ensure its being durable & can be used to connect to an antenna (instrument base)..
【Lightweight&Cost-saving】The original QCX circuit is greatly simplified, and the installed components are reduced by 50 percent to save you the trouble of complicated transformer windings and wiring procedures..
【Less Power Consumption】Thanks to the EER transmitter E-level, it boasts high power efficiency and no bulky heat sink is required..
【DSP Function】Automatic gain control (AGC), noise reduction (NR), voice trigger, voice trigger Xmit (VOX), RX attenuator attenuator (ATT), TX noise gate, TX driver control, volume control, dBm/S-meter..
【Quality Material Handling】Laser marking aluminum laser, aluminum knobs with translucent silicone buttons..

Attenuation Factor and Step Size :The HMC472 is a wideband 6-bit digital attenuator with an attenuation range of 0 to 31.5 dB and a typical step error of ± 0.25 dB..
Operating Frequency Range :Adopt QFN surface mount package, uses single power supply 5V, working frequency range from DC to 3.8 GHz..
Insertion Loss :Insertion loss is less than 2.0 dB (typical) and IIP3 is +54 dBm..
Objects Used :Suitable for a variety of RF and IF applications..
Attenuation Control Interface :Manually adjust the control through the 6-position pin header on the board..

Replacement for Part Number: B31N1535 3ICP7/60/80 0B200-02020000.
Compatible Models: For Asus Zenbook UX310 UX310UA UX310UA-1A 1C UX310UA-FB035T FB038T FB097T FC062T FC073T FC075T FC088T FC089T FC106R FC114T FC132T FC137T FC153T FC255T FC331T FC347T FC348T GL003T GL011T GL085T GL123T GL151T RB52 UX310UQ UX310UQ-1A 1C FC396T GL011T UX410UA GV010T UX410UQ UX410UQ-1A 1C Series..
High recycle life,high energy density and long life battery.
12Months warranty ,30Days money retum guarantee.

The HT201 has been designed to allow fuel injector and primary ignition waveforms to be measured using Hantek oscilloscope products..
Please note this attenuator should not be used for any high voltage measurements other than fuel injectors and primary ignition..
Passive attenuator with 20:1 attenuation, if input a 20V signal, it can output a 1V signal.Because the signal is attenuated, by using this item, oscilloscope can measure voltage higher than its range(±20V).
【What you will get】 1 x HT201 Signal Attenuation.
【Please Note】 After receiving the product, please check whether it is damaged. If you have any questions, please contact us in time. This product is a consumable and needs to be replaced regularly. Once the product is used, the warranty is not allowed..

Large Range: The measuring power range of this RF power meter is -60～-5 dBm (External RF attenuator can be extended to 100dBm), and the frequency range is up to 8000MHz..
Specific Feature: The RF power meter is light, compact and convenient, with a measurement power resolution of 0.1 dBm, and an output interface SMA_K..
Clear Display: This RF power meter comes with an LED screen, the data is clear and straightforward, and it is easy to use..
Standard Structure: The precise mechanical structure of the RF power meter makes the measurement accurate, convenient and reliable..
Quality Assurance: The RF power meter has been inspected many times before it leaves the factory to confirm the quality..

★【 Specification 】Size 12.3*2.3*1.14 inch (Over all length 12.3 inch including the pin). 365nm wavelength blue light,U-shapped tube.
★【 Compatible 】Flowtron BK-80D, FC7600, GL-2400, FC-2600, FC-4400, FC4410, FC-4800, FC-4810, FC-4700, FC-7200, FC8800, PM-2040A, PM-2080,....
★【 Suggestion 】Please confirm the bulb size before ordering(12.3 inch overall length including the pin). Suggest replace the blub every 5 month....
★【 Easy to install 】Just twist and remove the tray, then remove the screws and bulb, then insert the replacement bulb, making sure it is....
★【 Satisfaction 】100% SATISFACTION. We vouch for 1-year warranty and 3-month free return. Within 30 days from the date of purchase, if the price....