Best Engine Oil Pump Pickup Tube Gasket

MAHLE Original 41940.030 Ford 6.0L Power Stroke & Navistar VT275/365 & MaxxForce 5 0.030\ Piston Ring Set, 8 Pack

  • THIS KIT INCLUDES: Piston Set, Piston Ring Set, Main Bearings Set, Rod Bearings Set, Head Gasket Set, Lower Gasket Set, Freeze Plug Set (Brass), Cam Bearings, Timing Chain Kit, Oil Pump.
  • FITS: 87-90 Cadillac, Chevrolet, Pontiac / Brougham, Camaro, Caprice, Firebird 5.7L V8 OHV Naturally Aspirated.
  • FITMENT NOTES: w/ Oil Pump & Timing Belt Or Timing Kit If Applicable, Dish Pistons, Master Kit, w/ 3/4 Inlet Pump, w/ 3/4 Inlet, w/o IG3173, w/ Oil Pump & Timing Belt Or Timing Kit If Applica.
  • You are assured to receive a worldwide proven Master Engine Rebuild Kit quality part with OE quality fit and performance..
  • IMPORTANT: This Engine Kit is in STANDARD SIZE in all of its components. If you need oversized Pistons, Piston Rings, Rod Bearings or Main Bearings, send us a message prior ordering, indicating the correct size you need, so our customer service team can confirm availability. If we do not receive communication from you, everything will be sent in STANDARD SIZE by default.
Check Stock

Vevitts 80w Oil Change Extractor Pump 12V Oil Extractor Pump for Changing Diesel Fluid Scavenge Suction Oil Transfer Pump Kits for Jet Ski, Truck, RV, ATV, Boat (Red)

  • 【Instructions for use】1. Please pay attention to the direction of the inlet and outlet, the positive and negative poles and the locking hose lock before use.
  • 2. Please start the vehicle and heat the engine oil to 40-60 degrees for about 5 minutes, otherwise, the oil change pump may have low suction or get stuck. 3. CAN NOT be used to extract water, gear oil (too viscous) or flammable liquid (fuel, gasoline,kerosene,etc.)..
  • 【Complete Diesel Change Pump Kit】The oil transfer pump is mini but powerful. With 4.6ft Outlet tube & 4ft Inlet tube, the 8.2ft long battery clamps makes the extractor pump kit possible for being used at large range. The 2 hoops are used to tighten the tubes to avoid oil spilling..
  • 【12V 80w Oil Extractor Pump】Oil change pump, a great helper for quick and clean oil changing and transfer, all parameter is verified by multiple test. Diesel Flow Rate: 3.5L/min, Engine Oil Flow Rate(40-60℃): 1L/min, Inlet Tube Length: 1.2m/47.2in, Outlet Tube Length: 1.4m/55.1in, Voltage: 12V, Maximum current: 5A..
  • 【Premium Quality】We use pure copper for motors.Good conductivity, corrosion resistance and rust resistance, effectively avoid leakage or short circuit. Instead of manual operation, it can help you change oil quickly and cleanly....
Check Stock

Z Whip LS Oil Pump Pickup Tube Girdle Pipe Hold Down Brace Support Billet Bracket MADE IN THE USA Compatible with GM Chevy LS Series Engines LSX LS1 LS3 LS2 LQ4 LS6 LQ9 5.3L 6.0L 6.2L

  • Compatible with all LS Series Engines 1997-2014 (GEN. III/IV small block chevy).
  • The factory oil pickup tube on LS engines is only secured by one bolt. This can potentially lead to a poor seal on the oil pump. Our Billet aluminum Oil pump girdle solves the issue by placing a clamp on both sides of the tube, securely holding it in place..
  • DOES NOT fit any LS oil pickup tube with welded flanges (GM # 12608593, Holley 302-1 and similar tubes). DOES NOT fit pickup tubes with two screw holes on their flange (Holley 302-2 tube and similar tubes)..
  • Proudly made in the USA from Aerospace Grade Billet Aluminum.
  • We are an AS9100D and ISO 9001:2015 Certified Manufacturer. Parts we produce fly at 30,000 feet where failure is not an option..
Check Stock

Engine Oil Pump Pickup Tube Compatible with 2004 2005 2006 LS1/LS2 Pontiac GTO #12572654

  • New GM OEM oil pump pickup tube. This is for GTO oil pans only..
  • Oil pump pickups are specific to the oil pan..
  • If you are swapping an LS motor, you need to order a pickup specific to the pan you are using..
  • 100% Brand New , reliability and durability. Kindly do not hesitate to contact us back in the future if you feel that you need further assistance..
Check Stock

DNJ EK900 Engine Rebuild Kit for 1985-1995 / Toyota / 4Runner, Celica, Pickup / 2.4L / SOHC / L4 / 8V / 2366cc / 22R, 22RE, 22REC

  • THIS KIT INCLUDES: Piston Set, Piston Ring Set, Main Bearings Set, Rod Bearings Set, Full Gasket/Sealing Set, Thrust Washer, Freeze Plug Set (Brass), Piston Pin Bushings.
  • FITS: 85-95 Toyota / 4Runner, Pickup, Celica 2.4L L4 SOHC Naturally Aspirated 22RE,22R,22REC.
  • FITMENT NOTES: w/o Oil Pump & Timing Belt Or Timing Kit.
  • You are assured to receive a worldwide proven Engine Rebuild Kit quality part with OE quality fit and performance..
  • IMPORTANT: This Engine Kit is in STANDARD SIZE in all of its components. If you need oversized Pistons, Piston Rings, Rod Bearings or Main Bearings, send us a message prior ordering, indicating the correct size you need, so our customer service team can confirm availability. If we do not receive communication from you, everything will be sent in STANDARD SIZE by default.
Check Stock

The ROP Shop | 2400 PSI Power Pressure Washer Water Pump for Excell & Devilbiss VR2400, VR2500

  • Includes - (1) Vertical Pressure Washer Pump with Chemical Injector, Unloader Valve, Thermal Release Valve & Outlet Tube (come installed).
  • This pump is for vertical gas engine driven units. In some instances, the pump may need to be removed to change engine oil. The mounting flange provides a convenient connection to most 7/8” diameter shaft vertical gas engines in 4.5-7 HP. The pump has a hole in the leg for draining the engine oil. The pump includes a built-in pressure control valve, downstream chemical injection system and thermal relief valve.
  • This has the outlet facing the front. Some specific pressure washers may require longer bolts and spacers to mount the pump to your engine. These bolts and spacers are NOT included, but may be purchased at your local hardware store. Common bolt sizes: Two - 5/16" 18 x 2 1/2", One - 5/16" 18 x 3 1/2".
Check Stock

Diesel Water Parking Heater Hydronic Heater 5KW 12V Boat Caravan Motorhome Truck Camper Trailer Remote Control Diesel Water Heater Kit

  • PROTECT YOUR ENGINE ➤ The water heating type parking heater uses automobile coolant to exchange heat, preheats the engine and the cab, solves the problem of difficult engine startup at low temperature, greatly reduces air-cooled wear caused by low temperature startup, and extends engine life by more than 30%..
  • LESS FUEL PREHEATING ➤ Compared with cold-start engine preheating, the water heating parking heater preheating consumes less fuel. In the cold winter, you can warm up the engine and cab before getting on the car to drive away the severe cold. Improve the driving environment and no longer need a warm store..
  • FULL INSTALLATION SET ➤ 1 x Water Parking Heater, 1 x Auto Switch And Remote Control (Batteries Not Included), 1 x Water Pump, 1 x Wiring Harness, 1 x Tube, 1 x Oil Pump, 1 x Pump Holder, 1 x Fuel Filter, 1 x Oil Tube, 1 x Big Elbow, 1 x Small Elbow, 1 x Air Inlet Hose, 1 x Exhaust Pipe, 1 x Exhaust Silencer, 1 x Hose Holder, 1 x Cross, 1 x Air Filter, 6 x Short Pipe, 1 x Oil Extractor, 12 x Hose Clamps, 12 x Small Hose Clamp, 5 x Screwiv, 4 x Screw, 1 x Iron Stent..
  • TECHNICAL PARAMETERS ➤ Material: Metal &....
Check Stock

Ruma Carburetor Air Cleaner Air Housing Recoil Starter Kit for Honda GX120 GX160 GX200 Harbor Freight Predator 212cc 173cc Lifan Rato Loncin Engine Power Equipment

  • This kit includes carburetor, air cleaner assembly, recoil starter assembly, on off engine stop switch, spark plug, fuel tube,tube clips fuel joint, gasket set for carburetor, muffler and valve cover,, nuts for carburetor and muffler, bolts for recoil starter. It's a perfect rebuilding kit for your motors. Quality warranty. Full refund if any issue..
  • Fits Honda GX120 GX160 GX200 engine,water pump, pressure washer, compressor and more other equipment with the mentioned engines.
  • Fits Harbor Freight Predator 212CC 173cc 6.5Hp, 7Hp,R210 Lifan, Rato, Loncin engine, cart, pressure washer, water pump, compressor 56174 56172 63079 63080 63089 63090 67561 69676 67560 68121 68120 68527 68528 69727 69729 69730 96838 96898.
  • Harbor Freight Greyhound 196CC 6.5HP LIFAN - 66014 66015.
  • Harbor Freight Central Machinery 96549 96500 94187 and more.
  • Fits Generac 196cc 208cc engine and other equipment.
Check Stock

BOYISEN Oil Change Pump Extractor 12v 60W Oil Extractor Pump Diesel Fluid Transfer Scavenge Suction Pump Oil Quick Changer for Car, Boat, Marine, Motorbike, Truck, RV, ATV(Yellow)

  • 【Efficient Electric Pump】Oil change pump, a great helper for quick and clean oil changing and transfer, all parameter is verified by multiple test. Diesel Flow Rate: 1.5L/min, Engine Oil Flow Rate(40-60℃): 0.3L/min, Inlet Tube Length: 1.2m/47.2in, Outlet Tube Length: 1.4m/55.1in, Voltage: 12V, maximum current: 5A, maximum power: 60W.
  • 【NOTES】A, This oil transfer pump CAN NOT transfer WATER, GASOLINE, PETROL, FUEL or FLAMMABLE LIQUID. B, Please DO NOT misplace the direction of import and export, positive and negative poles and secure the hose clamps. C, Heat up your engine oil to 104°F-140°F before pumping D, We tested oil pump before shipping, there might be little oil stain in the pump, kindly understand. E, To make it last longer, it’s recommended to keep a little oil inside when the extractor pump is not in use..
  • 【Premium Quality】The quality of oil change pump extractor varies widely. We are using pure copper for the motor and alligator. Good electrical conductivity, corrosion resistance and rust free, effectively avoid leakage or short circuit. Overheat protection will cut off the power supply automatically for safety.
  • 【What You Get】The diesel change pump come with 2 outlet hose, 2 inlet hose, 4 hose locks and 2 battery clips. A....
Check Stock