Best Engine Oil Pump Intermediate Drive Shaft

JDMSPEED New HEI Red Cap Distributor Replacement For Ford FE V8 Engines 65000 Volt 352 360 390 427 428

  • THESE DISTRIBUTORS ARE FOR THE "FE" BLOCK ENGINES THAT USE THE 1/4" OIL PUMP DRIVE SHAFT.
  • THESE WILL NOT WORK FOR INDUSTRIAL "FE" ENGINES THAT USE THE 5/16" OIL PUMP SHAFT.
  • This is a must for those wishing to upgrade the ignition system to a HEI.
  • Please see below description for more details.
Check Stock

Northstar Gas Cold Water Portable Pressure Washer Power Washer - 4200 PSI, 3.5 GPM, Honda Engine, Model Number 157127

  • Honda GX390 OHV engine for quiet, reliable performance.
  • CAT 66DX direct drive crankshaft triplex pump with thermal protection and ceramic plungers.
  • Oil drain cutouts for quick, clean engine and pump oil changes.
  • Easy Start prevents pressure buildup for smoother, easier recoil pulling.
  • Adjustable pressure allows easy control of the PSI to suit any job.
Check Stock

Diesel Water Parking Heater Hydronic Heater 5KW 12V Boat Caravan Motorhome Truck Camper Trailer Remote Control Diesel Water Heater Kit

  • PROTECT YOUR ENGINE ➤ The water heating type parking heater uses automobile coolant to exchange heat, preheats the engine and the cab, solves the problem of difficult engine startup at low temperature, greatly reduces air-cooled wear caused by low temperature startup, and extends engine life by more than 30%..
  • LESS FUEL PREHEATING ➤ Compared with cold-start engine preheating, the water heating parking heater preheating consumes less fuel. In the cold winter, you can warm up the engine and cab before getting on the car to drive away the severe cold. Improve the driving environment and no longer need a warm store..
  • FULL INSTALLATION SET ➤ 1 x Water Parking Heater, 1 x Auto Switch And Remote Control (Batteries Not Included), 1 x Water Pump, 1 x Wiring Harness, 1 x Tube, 1 x Oil Pump, 1 x Pump Holder, 1 x Fuel Filter, 1 x Oil Tube, 1 x Big Elbow, 1 x Small Elbow, 1 x Air Inlet Hose, 1 x Exhaust Pipe, 1 x Exhaust Silencer, 1 x Hose Holder, 1 x Cross, 1 x Air Filter, 6 x Short Pipe, 1 x Oil Extractor, 12 x Hose Clamps, 12 x Small Hose Clamp, 5 x Screwiv, 4 x Screw, 1 x Iron Stent..
  • TECHNICAL PARAMETERS ➤ Material: Metal &....
Check Stock

4HP Outboard Motor Boat Engine, 4 Stroke Heavy Duty Outboard Motor Fishing Boat Engine with Water Cooling System (4-Stroke 4HP)

  • ①4 STROKE 4 HP OUTBOARD MOTOR ENGINE:The JET PUMP 4HP 4 Stroke Outboard Motor Boat Engine provides all the power you need for motoring in a small craft. This engine does that as well as providing fuel efficiency second to none and a newly redesigned carrying handle and holding grip make it convenient to transport!.
  • ②DETAILS: Model: 4.0 horsepower jet pump.
  • Refueling method: No. 92 unleaded gasoline is recommended..
  • ③SIZE INFORS: Packing volume: 95*42*29cm/37.4*16.5*11.4inch.
  • Gross weight/net weight: 13(28.66lb)/9.7kg(21.3lb).
  • Recommended engine oil: four-stroke engine oil.
  • ④ATTENTION:Use four-stroke special engine oil (automobile and motorcycle engine oil).
  • Add oil according to the scale indication on the oil dipstick (the rotating cover),do not add more or less.
  • The fuel tank of the four-stroke outboard engine can only be filled with....
Check Stock

TOOLCY 3/4" Shaft Horizontal Pressure Washer Pump - Max 3100 PSI @ 2.5 GPM - Power Washer Pump for Gas Washer - Replacement Pump for Honda, Simpson, Ryobi etc.

  • ...UMP】 Horizontal Power Washer Pump 3/4" Shaft MAX 3100 PSI / 2.5 GPM / @3400 RPM, Our replacement pump operation time is 150 hours, (50 hours longer than the market), so that you can save money for replace pressure washer accessories and time.Top performance at 2600-3100 PSI and fit most 208-240cc 6.0HP-8.0HP engine. Replacement for Simpson, Generac, Homelite, Honda, Karcher and more..
  • 【EFFICIENT WORK】Come with 3 special test matched nozzle tips (0°/25°/soap) for best cleaning performance.If you need a higher pressure cleaning pump, it is equipped with a larger 3100 PSI / 2.5 GPM flow rate to complete the cleaning job more efficiently, allowing you to easily start cleaning in more scenarios (eg. garden, house, car, road etc). ⚠ Will not fit 7/8 inch shaft gas engine..
  • 【SAVE WORRY】 It is made of die cast aluminum with deep surface treatment to prevent rust, the pump is maintenance-free crankcase, so there is no need for a lifetime of pre-filling gear oil, no oil change. Simply Replace it and Revive your Pressure Washer! We long for help you save more energy and time, this upgraded pressure pump will be your best choice.※►Diagonal distance betwee....
Check Stock

Comet ZWD 4040G Pressure Washer Pump 4 GPM 4000 PSI For 1\ Hollow Shaft Engines (Fully Plumbed with Unloader External Bypass)

  • 2800 psi 2.5 gpm Universal Power Pressure Washer Water Pump 308653052 for Homelite.
  • Specs - Maximum Pressure: 2800 PSI. Maximum Flow: 2.3 GPM. Maximum Pump Speed: 3400 RPM. Shaft Diameter: 7/8" Shaft. 3 Bolt Pattern: 7 11/16” x 6 3/16” x 6 7/16” & 4" Center to Each Outer Hole. Maximum Water Temperature: 140° F. Inlet Connection Type: Standard Garden Hose. Outlet Tube Connection: 22mm Male. Refer to images 2 and 3 for more information.
  • Includes - (1) Vertical Pressure Washer Pump with Chemical Injector, Unloader Valve, Thermal Release Valve & Outlet Tube.
  • This pump mounts vertical and is a rear facing (water inlets/outlets come out of the rear of the engine). Pump needs at least 5.5HP to handle PSI. Pump head can be flipped.
  • This pump may require 1/2" spacers when installed, depending on motor configuration. Spacers are used in the case that the pump arm(s) hits the engine or can't reach the under side of frame such as the engine has a longer shaft. If spacers aren't used when installing, the pump legs will break from stress.
Check Stock

EVAR V8 Engine Model Kit That Works for Adults, V8 Engine Internal Combustion Engine Model DIY Assembly Kit for AX90104 SCX10 Capra VS4-10 Pro/Ultra Model Car

  • Design: V8 internal combustion engine structure and principle design, pulley winding drive structure, generator, air conditioning compressor, steering pump, water pump, complete output flywheel and layered cylinder head, cylinder head cover, screw near and far valve intake manifold, oil pan structure, power drive plate plug interface..
  • Performance: based on pre colored products, users need to install. The V8 engine model can simulate electric operation. At the same time, considering the stability and reliability of operation, we made a full bearing structure of the drive part in a small space..
  • Application: Analog V8 engine is applicable to many RC models, such as AX90104, SCX10, Capra, VS4-10 Pro/Ultra. Installing this engine will make your remote control car unique and powerful, but it is also a good decoration, which can exercise the ability to assemble and restore the V8 engine..
  • Tip: This engine kit does not include a bracket. You can select the corresponding engine bracket according to your model. The engine and bracket are sold at the same time..
Check Stock

Pressure Washer Pump Replacement, 7/8'' Shaft Vertical Pressure Washer Pump, Power Washer Pumps Replacement, 2400-2800PSI Pumps Replacement for Pump Pressure Power Washer

  • · Pressure Washer Pump - 2800psi, Max 2.5 GPM RATING, Fits 7/8" Shaft Vertical Axial Gasoline Engines in 4-7 HP - Such as some models of Troybilt, Ryobi, Generac, Briggs & Stratton,Devilbiss/Excell,Craftsman,Husky,Honda. Not fit all model series. Very Important - This pump is a heavy item. In order to save each other’s time and money, Please check the pump shaft size 7/8’’, the pump housing and mounting size, and the pressure power fit your machine or not before you place the order..
  • · Vertical Power Pressure Pumps COMPATIBILITY - 2400-2800psi,4-7 HP Max.#PowerStroke:PS262311,PS80944,PS80946#Excell:VR2522,VR2500,#Craftsman:580series#Ryobi:RY802700,RY8C2700,RY802700A,etc #Husky: HU80 series #Homelite UT80709 series.It can fit other type models. This pump not fit all series models, pls check your pressure washer’s mounting size, pressure power and shaft size before you buy. If you are not sure if your pressure washer would fit, please contact ' Amazon Customer Service'..
  • · Pressure Washer Pump Parts - Comes with Easy start valve (EZ), Thermal relief valve, Unloader & SAE gas engine flange, M22 outlet, Copper Nut 3/4 NH inlet, Keyway Stock..
  • · Universal Pressure Washer Pump Replacement✦This pump is a universal pressure washer pump replac....
Check Stock

Canpump Pressure Washer Triplex Pump, 3,000 PSI at 3.1 GPM, 3/4-inch Horizontal Shaft

  • 3,000 psi at 3.1 gpm, 6.5 hp at 3,400 rpm, 3/4-inch hollow shaft, horizontal mount direct-drive, 4.78 mm keyway, 3/4-inch standard garden hose inlet, 3/8-inch quick-connect outlet, 50°C (122°F) max. inlet water temperature.
  • Replacement pump kit with near-universal compatibility for standard 3/4-inch shaft direct-drive gas engines from Honda, Annovi Reverberi, RIDGID, Blackmax, Generac, Husky, Excell, Troy-Bilt, Sears, Briggs & Stratton, Campbell Hausfeld and more.
  • Forged brass and anodized aluminum construction with cooling fins.
  • Durable 15 mm ceramic-coated solid stainless steel plungers.
  • Detachable and pressure-adjustable internal bypass unloader valve with detergent injector and built-in water filter.
  • Includes detergent tube with strainer, set of extra O-rings, pre-filled SAE 15W-40 oil, and operating manual with spare parts list.
  • 7x5 toll-free phone, email and live chat support from Canada.
Check Stock