Best Engine Oil Pump Inlet Screen

Upgrade Oil Change Pump Extractor, 12V 60W Motor Oil Diesel Fluid Transfer Pump Quick Oil Extractor Pump Scavenge Suction for Car Boat Motorbike Tractor Truck RV ATV

HIGH EFFICIENT: This oil transfer pump is an ideal equipment for quick easy and clean safety oil-changes. Flow Rate: 3L/min flow rate for engine oil, 4L/min for diesel. Voltage: 12V, maximum current: 5A, maximum power: 60W..
APPLICATION: This oil pump can change engine oil and diesel for cars, tractor, boat, motorbike, truck, RV and ATV and other 12V vehicles..
EASY INSTALLATION: You just need to place the inlet/outlet hoses at the appropriate positions, tighten the hose clamps, connect the power clamps anode and cathode to the car battery properly and press the button. Oil will be extracted by itself..
NOTE: To pump oil properly, please start the vehicle to heat up the oil (to 40~60 degrees)about 15 minutes. Otherwise, the oil change pump may have low suction or jammed..
WARNING: This oil pump is not use to extract water, gearbox-oil(too viscous) or flammable liquids (fuel, petrol etc)..

Check Stock

The ROP Shop | 2400 PSI Power Pressure Washer Water Pump for Excell & Devilbiss VR2400, VR2500

Includes - (1) Vertical Pressure Washer Pump with Chemical Injector, Unloader Valve, Thermal Release Valve & Outlet Tube (come installed).
This pump is for vertical gas engine driven units. In some instances, the pump may need to be removed to change engine oil. The mounting flange provides a convenient connection to most 7/8” diameter shaft vertical gas engines in 4.5-7 HP. The pump has a hole in the leg for draining the engine oil. The pump includes a built-in pressure control valve, downstream chemical injection system and thermal relief valve.
This has the outlet facing the front. Some specific pressure washers may require longer bolts and spacers to mount the pump to your engine. These bolts and spacers are NOT included, but may be purchased at your local hardware store. Common bolt sizes: Two - 5/16" 18 x 2 1/2", One - 5/16" 18 x 3 1/2".

Check Stock

PLUMIA 12V 100W Oil Change Pump Extractor, Upgraded Oil/Diesel Fluid Pump Extractor Scavenge Suction Transfer Pump, Marine Electric Oil Pump, For Boat, Car, Motorcycle, ATV, RV, Truck, Motorbike

...l pumps are needed by everyone, simple operation does not need to spend too much time to practice, widely used in motorcycles, Car, scooters, Boat, quad bikes, trucks, Ship, forklifts, Marine, Power generation machinery, tractors, lawn mowers and various machinery to change the oil..
【SAFE OPERATION】- Except for engine oil and diesel, the oil pump must not draw any flammable liquid or water to avoid accidents. Before use, be sure to heat the car engine to 104 ° F-140 ° F, Avoid clogging the oil pump due to oil solidification..
【ENGINE OIL CHANGE MADE EASY】 - DC 12V 100W has enough power, you only need to clamp the conductive clip on the motor and open the switch to start it, so that you can complete the oil pumping work smoothly and effectively, replacing the traditional oil change method and reduce tedious workload (diesel flow: 1.7L / m, oil flow 0.35L / m)..
【ACCESSORIES & PRECAUTIONS】- The oil pump has 2*outlet hose, 2*inlet hose, 4*hose locks,1*screwdriver, 1*Oil-proof gloves, 2*battery clips, 1*user's manual. Please pay attention to the direction of import and export, positive and negative poles and lock hose lock before use. The suction power of the micro suction pump is limited. Please do not connect other extension tubes..

Check Stock

Lotyes Quick Oil Change Pump, DC 12V 60W Oil Diesel Fluid Pump Extractor Transfer Pump & Tubes Kit for Car, Boat, Motorbike, Truck, RV, ATV and Other Vehicles

...s needed, the hoses and hose clamps in the package can prevent leakage during the extraction process..
Easy installation: Install the oil extractor inlet and outlet hose, tighten the hose clamps, connect the power clamps to the vehicles battery and switch the button on..
Versatility: This oil transfer pump can change engine oil and diesel for cars, boat, motorbike, truck, RV and ATV and Other Vehicles. WARNING: THIS PRODUCT CAN NOT USE TO EXTRACT WATER, GEARBOX OIL OR FLAMMABLE LIQUIDS(SUCH AS FUEL,PETROL,GASOLINE,ETC)..
What You Get: Lotyes oil extractor pump, outlet hose, inlet hose, hose clamps, battery clamps, user guide. We are certain that you will love the design and high quality of the product. Because you are our number 1 priority, we are offering premium customer support and money-back service for a risk-free purchase..

Check Stock

YSTOOL 10L Pneumatic Fluid Extractor Dispenser Set ATF Refill Tool Kit for Changing Oil in Engine Transmission Differential Transfer Case Gear Gearbox Power Steering Coolant with Pump Assembly Tank

YSTOOL fluid extractor and dispenser tool kit includes 3PCS 1M dipstick tubes, can insert into engine dipstick tube to extract and refill engine oil or transmission fluid directly, no more need to crawl about under lifted vehicles and avoid mess. Also can insert into any insertable pipe or tank to change non-corrosive and low-consistency liquids (such as differential fluid, transfer case fluid, gear oil, power steering fluid, coolant, water) in vehicle, jet ski, lawn mower or other small engine.
This ATF engine oil refill tool set provides 15PCS ATF adapters to fit a variety of vehicle models, add oil from fill plug or help to push transmission fluid into the engine through the drain plug on the transmission pan. All the 15PCS metal adapters are marked with NO. and well packed in a case, compatible with Ford, BMW, Nissan, Honda, Audi, VW DSG, VW CVT, Skoda, Porsche, Benz, Mini Cooper, Kia, Toyota, Hyundai, Infiniti, VOLVO and Lexus. You can find appropriate models by applicable manual.
YSTOOL pneumatic oil change tool set allows two-way operation of oil suction and refueling, quick and sparkless. Absorb, transport and distribute liquids under safe and clean conditions. The consistent conversion of the 2-way control valves (blue screw valve and air inle....

Check Stock

THINKWORK Oil Pump Extractor, 12V 80W Marine Oil Change Pump and Electric Oil Pump, with Overheat Protector for Boat, Car, Speedboat, Motorcycle

SAFETY&OVERHEATING PROTECTION-Except engine oil, diesel oil and coolant, the oil pump must not pump any flammable liquid or water to avoid accidents. Before use, be sure to heat the car engine to 104°F-140°F for about 15 minutes to avoid clogging the oil pump due to the solidification of the oil. When the oil pump is overheated, the newly added overheat protection device will automatically cut off the power supply. At this time, please check whether the hose is blocked or the oil is too sticky..
QUICK OIL CHANGE - DC 12V 80W has enough power, you only need to clamp the conductive clip on the motor and open the switch to start it, so that you can complete the oil pumping work smoothly and effectively, replacing the traditional oil change method and reduce tedious workload (diesel flow: 1.5L / m, oil flow 0.3L / m)..
UPGRADED OIL PUMP-Everyone needs a portable and small oil pump, simple operation does not need to spend too much time for practice, widely used in motorcycles, scooters, ships, quad bikes, trucks, ships, forklifts, power generation machinery, tractors , Lawn mowers and various machinery to change the oil..
ACCESSORIES & PRECAUTIONS - The oil pump has 1 outlet hose, 1 inlet hose, 2 hose locks and 2 battery clips. Please pay attention to the ....

Check Stock

EONLION 10L Pneumatic Fluid Extractor Dispenser Set ATF Refill Tool Kit for Changing Oil in Engine Transmission Gear Gearbox

Function-10L capacity pneumatic air suction pump will help you quickly change (pump/distribute) the vehicle's ATF oil..
Why Need It- Pneumatic oil change tool set allows two-way operation of oil suction and refueling, quick and sparkless. The consistent conversion of the 2-way control valves (blue screw valve and air inlet ball valve) on the pump assembly to achieve the conversion between extracting and dispensing, very easy..
Advantage- Fluid extractor can insert into engine dipstick tube to extract and refill engine oil or transmission fluid directly, no more need to crawl about under lifted vehicles and avoid mess..
Simple Operation-load more fluid at once. Pneumatic operation, easy to suck or pump oil. Equipped with pressure gauge (0-80 psi/0-6 bar), which can accurately read data..
Fitment- Suitable for a variety of models, such as compatible with Audi/Benz/BMW/Ford/Mini Cooper/Honda/Hyundai/Infiniti/Kia/Lexus/Nissan/Skoda/Toyota/Porsche/Volvo/Volkswagen DSG/Volkswagen CVT..

Check Stock

Diesel Water Parking Heater Hydronic Heater 5KW 12V Boat Caravan Motorhome Truck Camper Trailer Remote Control Diesel Water Heater Kit

PROTECT YOUR ENGINE ➤ The water heating type parking heater uses automobile coolant to exchange heat, preheats the engine and the cab, solves the problem of difficult engine startup at low temperature, greatly reduces air-cooled wear caused by low temperature startup, and extends engine life by more than 30%..
LESS FUEL PREHEATING ➤ Compared with cold-start engine preheating, the water heating parking heater preheating consumes less fuel. In the cold winter, you can warm up the engine and cab before getting on the car to drive away the severe cold. Improve the driving environment and no longer need a warm store..
FULL INSTALLATION SET ➤ 1 x Water Parking Heater, 1 x Auto Switch And Remote Control (Batteries Not Included), 1 x Water Pump, 1 x Wiring Harness, 1 x Tube, 1 x Oil Pump, 1 x Pump Holder, 1 x Fuel Filter, 1 x Oil Tube, 1 x Big Elbow, 1 x Small Elbow, 1 x Air Inlet Hose, 1 x Exhaust Pipe, 1 x Exhaust Silencer, 1 x Hose Holder, 1 x Cross, 1 x Air Filter, 6 x Short Pipe, 1 x Oil Extractor, 12 x Hose Clamps, 12 x Small Hose Clamp, 5 x Screwiv, 4 x Screw, 1 x Iron Stent..
TECHNICAL PARAMETERS ➤ Material: Metal &....

Check Stock

THINKWORK Oil Pump for Oil Change, 12V 80W Electric Oil Pump and Marine Oil Change Pump, Upgraded Oil Change Pump Extractor with Handle for Boat, Car, Motorcycle

...ough power, you only need to clamp the conductive clip on the motor and open the switch to start it, so that you can complete the oil pumping work smoothly and effectively, replacing the traditional oil change method and reduce tedious workload (diesel flow: 1.5L / m, oil flow 0.3L / m)..
SAFE OPERATION - Except for engine oil and diesel, the oil pump must not draw any flammable liquid or water to avoid accidents. Before use, be sure to heat the car engine to 104 ° F-140 ° F (40℃-60℃) about 15 minutes to avoid clogging the oil pump due to oil solidification..
ACCESSORIES & PRECAUTIONS - The oil pump has 1 outlet hose, 1 inlet hose, 2 hose locks and 2 battery clips. Please pay attention to the direction of import and export, positive and negative poles and lock hose lock before use. The suction power of the micro suction pump is limited. Please do not connect other extension tubes..
THINKWORK GUARANTEE SERVICE - we provide satisfactory and reliable customer service. If there is any problem with this oil pump, please contact customer service in time, and you will get a satisfactory result..

Check Stock