Best Engine Oil Kit

Engine Oil Cooler Kit - Compatible with Ford Trucks - Powerstroke 6.0L V8 F250, F-350, F450, F550 Super Duty, Excursion, E350, E-450 - Replaces Part 904-228, OCK388, 3C3Z 6A642 CA - Gasket Seal Kit

  • Replacement Engine Oil Cooler With Gasket Seals & O-Rings - Is a heat-exchanger which is commonly a radiator type of cooler which cools engine oil from the engine. It removes excess heat from the oil using the engine coolant that flows around as the engine oil passes through the cooler. The engine oil cooler can be located under the intake above the engine..
  • Compatible Replacement for Ford Vehicles - 2004 - 2005 E-350 Club Wagon | 2004 - 2010 E-350 Super Duty | 2004 - 2007 E-450 Super Duty | 2003 - 2005 Excursion | 2003 - 2007 F-250 Super Duty | 2003 - 2007 F-350 Super Duty | 2003 - 2007 F-450 Super Duty | 2003 - 2007 F-550 Super Duty |..
  • Replaces Part# 3C3Z 6A642 CA, 904228, 904-228, 015339, OCK388, 3C3Z-6A642-CA, 3C3Z6A642CA - If you are noticing engine oil in your coolant system, oil or coolant leaking from the oil cooler or engine coolant mixed with your engine oil then your oil cooler might need to be looked at or replaced. This engine oil cooler kit also includes viton gasket seals needed for the proper service on your vehicle..
  • OEM Fit, Quality, Finish - While this is not a genuine OEM part, it is a direct replacement and it will fit and work exactly like the factory part. This part is commonly found on popular Powerstroke 6.0 V8 models....
Check Stock

Polaris PS-4 Full Synthetic Engine Oil, 4-Stroke Engines

  • For those that know a job done right is done yourself: the 4T 0W-40 Synthetic Oil Change Kit for Rotax 600 ACE engine.
  • Easy to use, the all-in-one kit includes XPS Synthetic Oil, an oil filter, o-rings, and a washer.
  • The kit provides you with everything you need to change the oil of your Ski-Doo yourself.
  • This is a factory original equipment item, not an aftermarket.
Check Stock

Seeutek 80cc Bicycle Engine Kit 26" 28" Bike Bicycle Motorized 2 Stroke Cycle Petrol Gas Motor Engine Kit Upgrade with Speedoemter

  • 80cc bicycle engine kit with speedometer.This bike engine kit fits most mens' 24" and larger bicycles which includes mountain,cruiser,chopper and road bikes with a V-frame, at least a 8.5" height clearance for the engine. Large bikes (larger frames/down tubes) may require the universal mount. Notes: Be assured the mixing ratio for gas and oil:16:1 for break period (first 300 miles)/20:1 after to avoid motor lock up or piston seized. Please read attached instruction manual before installation..
  • 80cc bike motor kit, Mode of engine: single cylinder, air-cooling, 2-stroke.
  • chain length:110 links, 55 inches. Driving ratio:18: 01.
  • lubrication oil: motorcycle synthetic 2 stroke oil. Notes: Fuel Type:Gas 93# and please use premium quality oils to prolong engine life. And add some lubricant into the air cylinder before starting..
  • Horse power: 2.75 HP. Ignition type: CDI. Engine Type: Single cylinder, air-cooling, 2-stroke.
  • Chain Length: 110 links. Larger frame size requires drilling into bike frame and use of the universal face plate.Notes:If new carb ....
Check Stock

MOTOOS 80CC 24' 26' 28' 2 Stroke Bike Bicycle Motorized Cycle Engine Motor Kit (Red)

  • Single Cylinder, Air-Cooling, 2-Stroke Gasoline Engine. This 2-stroke 80cc engine kit is perfect to upgrade the regular bike to a motorized bike, which allows you to enjoy riding at a faster speed, which can reach 38km/h as fast as a motorcycle or scooter..
  • The bicycle engine kit is designed for users who want to retrofit and upgrade a bicycle. Suitable for most 26" and 28" bicycles with V-frames. The frame should have 9-11" of clearance between the bottom bracket and top bar, and the diameter of the frame tubes should be 25-29mm (around an 1")..
  • Key parameters: bore and stroke-47mm & 40mm, Max. power 3 horsepower/5000r/min, Super fuel-efficient, only consuming 2.5L fuel/100km..
  • Lubrication Oil: oil for 2-stroke petrol engine (or oil for 10W/40.10W/30).
  • Mixing Ratio of Fuel and engine Oil: 16:1 for new sets, 20: 1 after running 500km..
  • Mode of Engine: Single cylinder, air-cooling, 2-stroke Natural air cooling.
  • The rider needs some basic hardware tools, skills and around 2-3 hours to install. Add some lubricant into the air cylinder before starting. NOTE: Due to the chemical reaction of electrophoresis, the engine motor of the product will have a certain proportion of color difference. Please mind to buy it carefully..
Check Stock

SUNROAD 80cc Bicycle Engine Kit 24″ 26″ 28″ 2-Stroke Motorized Bicycle Petrol Gas Engine Kit Red

  • Single Cylinder, 2-Stroke Gasoline Engine. Air-Cooling,Equipped with the 2-stroke 80cc single cylinder gasoline engine, our bike motor kit is suitable for most bikes with v-frame. It will better upgrade your regular bike to a motorized bike and let you enjoy the fun of riding..
  • The bicycle engine kit is designed for users who want to retrofit and upgrade a bicycle. Suitable for most 26″ and 28″ bicycles with V-frames. The frame should have 9-11″ of clearance between the bottom bracket and top bar, and the diameter of the frame tubes should be 25-29mm (around an 1″)..
  • Key parameters: bore and stroke-47mm & 40mm, Max. power 3 horsepower/5000r/min, Super fuel-efficient, only consuming 2.5L fuel/100km..
  • Lubrication Oil: oil for 2-stroke petrol engine (or oil for 10W/40.10W/30).
  • Mixing Ratio of Fuel and engine Oil: 16:1 for new sets, 20: 1 after running 500km..
  • Mode of Engine: Single cylinder, air-cooling, 2-stroke Natural air cooling.
  • The rider needs some basic hardware tools, skills and around 2-3 hours to install. Add some lubricant into the air cylinder before starting. NOTE: Due to the chemical reaction of electrophoresis, the engine motor of the product will have a certain proportion of color difference. Please mind to buy it carefully..
Check Stock

Engine Oil Cooler and Filter Housing Adapter Kit - Replaces 68105583AF, 68105583AE - Compatible with Chrysler, Dodge & Jeep 3.6L V6 Vehicles - 200, Town & Country, Grand Caravan, Wrangler, Ram

  • Replacement Engine Oil Cooler & Filter Housing Adapter Kit - With Intake Manifold Plenum Gasket Set - Keeps the engine oil clean as it circulates through the engine. This replacement Oil Filter Housing Adapter Kit also comes with a new oil filter pre-installed for a complete and worry free installation. If you are experiencing oil leaks above the transmission or near the cooler housing where the oil filter is then you may have a problem with your oil filter housing adapter..
  • Compatible Replacement for Dodge, Chrysler & Jeep Vehicles With 3.6L Pentastar V6 Engine - 2014 - 2017 200 | 2014 - 2017 300 | 2014 - 2016 Town & Country | 2014 Avenger | 2014 - 2017 Challenger | 2014 - 2017 Charger | 2014 - 2015 Durango | 2014 - 2016 Grand Caravan | 2014 - 2016 Cherokee 3.2L | 2014 - 2015 Grand Cherokee | 2014 - 2017 Ram 1500 | & more. See below for full vehicle list..
  • Replaces Part# 68105583AF, 68105583AE, 68105583AA, 68105583AB, 68105583AC, 68105583AD usually found on popular , Journey, Wrangler, Ram Promaster 1500, 2500, 3500 including year models 14, 15, 16, 17. The oil filter housing can easily be located above the engine and can be accessed by removing the intake manifold. It is best and practical to replace the whole housing rather than waste time....
Check Stock

Universal Car Oil Catch Can Kit Polish Baffled Automotive Reservoir Tank 300ml with Breather Aluminum Compact Dual Cylinder

  • ★ MAINTAIN EXCELLENT ENGINE PERFORMANCE - EIGIIS Oil Catch Can Kit prevents sludge from accumulating in the valve and intake manifold, keeping the engine clean. Increase horsepower and maintain engine life by removing oil from the PCV valve from the intake manifold..
  • ★ EASY TO CLEAN - EIGIIS Oil Catch Can Kit is fully Tig Welded and Thread Come with O-ring Gasket to Prevents oil leakage. You also don't need dismount it, just need to unscrew the bottom part of the reservoir, then you can clean it down easily..
  • ★ SAVE FUEL CONSUMPTION - EIGIIS Oil Catch Can Kit can effectively reduce the fuel consumption of high-speed engines and turbine engines. There is also a washable stainless steel screw on the filter/venting hole with a hose clamp to prevent loosening..
  • ★ HIGH QUALITY MATERIAL - EIGIIS Oil Catch Can Kit is made of high quality 0046 aluminum for added strength and durability. The capacity is 300ml,enough for daily use.Universal for most car such as Subaru,2014 Santa Fe and 2013 Sonata,Mazda MX-5 etc..
  • ★ ATTENTION- 100% product quality assurance. Please feel free t....
Check Stock

KIMISS Towing Hitch Engine Oil Coolers & Kits, Motorcycle Engine Oil Cooler Oil Cooling Radiator Kit for Honda CB CG 100CC-250CC(85ML-Silver)

  • 【Required accessories】Whether you're using a top-down corner engraving or pulling down a tow, your high speed requires a reliable and efficient cooling system..
  • 【Minimal pressure loss】With minimal pressure loss, the kit uses a large oil drain cooler mounted in the front grille for optimum airflow and cooling..
  • 【Funtion】Cooling the engine temperature keeps the engine within normal operating temperature range, reducing engine load and extending its life..
  • 【Two choices】Invisible black and stylish silver cooler options include pre-assembled stainless steel cords and special mounting brackets for a painless, clean installation..
  • 【Fitment】Motorcycle Oil Cooler System Kit, Fit for Honda GY6 100CC-150CC Engine. Transmission Cooler Mounting Kit Oil Cooler Lines.
Check Stock

FEWENi 80cc 2 Stroke Bicycle Engine Motor Gas Motorized Bike Motor Kit

  • Ambienceo 2-stroke 80cc engine kit is perfect to upgrade the regular bike to a motorized bike,which enable you to enjoy riding at a faster speed, which can reach 38km/h as fast as a motorcycle or scooter..
  • The bicycle engine kit fits most 26" or 28" wheeled bikes (Mountain, Cruiser, Chopper, Road) with V-frame. The frame should have 9-11" of clearance between the bottom bracket and top bar, and the diameter of the frame tubes should be 25-29mm (around an 1").
  • Key parameters: bore and stroke-47mm & 40mm, Max. power 5 horsepower/6000r/min, Super fuel-efficient, only consuming 2.5L fuel/100km.
  • Lubrication Oil: oil for 2-stroke petrol engine (or oil for 10W/40.10W/30).
  • Mixing Ratio of Fuel and engine Oil: 16:1 for new sets, 20: 1 after running 500km.
  • The rider needs some basic hardware tools, skills and around 2-3 hours to install. Add some lubricant into the air cylinder before starting..
Check Stock