Best Enclosure Ground Wire Clamp

WYNNsky Magnetic Welding Support Ground Clamp, 2pcs Set, Single and Double Welding Head, Copper Tail

  • Design: This magnetic clamp attaches easily to any smooth metal surface, flat or curved. It holds on tightly, without budging easily. Super suction magnet at the bottom, large suction power, long-lasting magnetism..
  • Application: This device serves as the ground point, which you can take with you anywhere. Simply tack this onto a convenient spot, hook up your safety wire and you're ready to weld..
  • Material: The welding magnet head adopts high quality material, durable and solid. Has brass tail has good welding stability, durable, anti-rust, has good performance and long service life..
  • Advantage: This magnetic clamp is handy to have in such situations. You can stick in on a car body and not have to damage the paint. The clamp can also be attached to metal poles, struts, railings or the welding table..
  • Including 1pc Single Head Magnetic Welding Ground Clamp.
  • 1pc Double Head Magnetic Welding Ground Clamp.
  • 1pc Copper Tail Welding Stability Clamps..
Check Stock

Memphis Audio MJP1244 12 in 1500 Watt MOJO Pro Car Audio Subwoofer DVC 4 ohm Sub, Black

  • ...des: (1) Memphis Audio MJP1544 15″ 1500 Watt MOJO Pro Car Audio Subwoofer DVC 4 ohm Sub. (1) Rockville dB13 3000 Watt Peak/750w RMS Mono 2 Ohm Amplifier Car Amp. (1) Rockville RWK41 4 Gauge Complete Car Amp Wiring Installation Wire Kit with RCA’s. (1) Rockville RSQ15 Single 15″ 2.6 cu.ft. Sealed Car Subwoofer Enclosure Sub Box. (1) Complete Single Sub Box Enclosure Installation Kit: Speaker Wire, Screws, Spades.
  • Features of MJP1544: Specifically designed for high SPL performance. DVVC Direct Vent Voice Coil Cooling. Cross drilled front plate venting. Aluminum shorting ring for reduced inductance. Foam surround. Rigid paper cone. Progressive spider. Diecast basket. Single Sided compression terminals. Size: 15 Inch. Voice coil: DUAL 4Ω. RMS/PEAK: 750/1500 Watts. SENS: 88 dB. DEPTH: 7.88 Inch. CUT OUT: 13.84 Inch.
  • Features of dB13: Rockville dB13 3000 Watt Peak/750w Dyno-Certified RMS Mono 2 Ohm Amplifier Car Amp. Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, RFFosgate, etc). – 2 Ohm: 750 Watts x 1 Channel .
  • Features of RWK41: 1 – 17’ High Grade Twisted Pair of 100% Copper RCA Cable. 17’ – 4 Ga....
Check Stock

Rockville DK512 PACKAGE Dual 12' 2800w K5 Car Subwoofer Enclosure+DB12 Amplifier

  • Loaded Sub Enclosure Features: Final Impedance: 2 Ohm, Peak Power Handling: 2800 Watts, CEA-2031 Compliant RMS Power Handling: 700 Watts, ¾” MDF enclosure, Bonded stapled and braced, Computer designed vents, Angled at 15 % for perfect bass alignment.
  • 2″ 4-Layer Black Aluminum Voice Coils Wound with OFC (100% Copper) Wire, The wire we use to wind the voice coil is imported from Japan which is way better quality than the standard China wire, 50 Oz High Quality Magnet.
  • Amplifier Features: Rockville dB12 2000 Watt/500w RMS Mono Class D 2 Ohm Amplifier Car Audio Amp, CEA Compliant Power Ratings (Rated at less than 1 % distortion).
  • RMS Power Ratings: (Use these RMS ratings when comparing with great brands such as Hifonics, Earthquake, Soundstream, etc.), – 2 Ohm: 1000 Watts x 1 Channel, – 4 Ohm: 600 Watts x 1 Channel.
  • Amp kit features: 1 – 17’ High Grade Twisted Pair of 100% Copper RCA Cable, 17’ – 4 Gauge Translucent Blue SuperFlex Power Cables, 17’ – 18 Gauge Blue Remote Cable, 17’ – 16 Gauge Clear Speaker Wire, 3’ – 4 Gauge Clear SuperFlex Ground Wire.
Check Stock

Forney Easy Weld 261, 140 FC-i Welder, 120V, Green

  • ...ows you to weld mild steel up to 1/4 in plate.
  • PORTABLE WELDER- Lightweight 19 lbs. easily carried to any Do-It-Yourself, Maintenance, Repair, Metal Fabrication and Hobbyist project.
  • RUGGED- All metal case, Built to take the day to day. Big enough to handle 2 and 10 pound rolls of wire.
  • WELDER INCLUDES- 8' MIG gun, 8' ground clamp, Integrated handle with torch wrap and a 20A-15A adapter. Backed by a 12-month warranty.
  • PRODUCT SPECIFICATIONS- Dimensions: 16.75" (425.45 millimeters) x 8.125" (206.38 millimeters) x 12" (304.8 millimeters), Weight: 19 lbs. (8.62 kilograms), Gasless/flux-core welding only, Portable, Torch wrap, Infinite voltage and wire feed speed control, 120-volt input, 140 AMP output, Welds up to 1/4 in. (6.35 millimeters), Handles .030 in. or 0.35 in. wire, Includes: 8' MIG gun, 8' ground clamp and 20A - 15A adapter, Duty Cycle 30% @ 90A.
  • RECOMMENDED ACCESSORIES- Contact Tips (60170, 60171 and 60172),Welding Nozzles: (85336 and 85337), Diffuser: (85339), Flux Core MIG Wire: (42300 and 42301), Anti-Spatter Spray: (37030), Nozzle Gel: (37031).
  • Click on the (BY FORNEY) name above in blue under the title to view our full catalog of Welders, Abrasives, Chain/Wire Rope, Tools and more!.
Check Stock

200A Magnetic Welding Ground Clamp, 200A On/off Adjustable Magnetic Welding Ground Clamp Rare Earth Switchable Magnet Welding Holder,Grounding Magnet Connector

  • Magnetic Welding Ground Clamp: Made of high quality iron, durable in use. High strength and hardness. Fast set up and grounds instantly. Applicable to clamp both flat and round workpieces..
  • 200A Magnetic Ground Clamp: Magnet Strength Pull Force 30 kg, Simple to connect, ground wire of welding machine. Simply place on clean surface and turn on then start welding. Stays clean because magnetic field turns completely off..
  • Easy to Use: Strong grip on flat or round iron surfaces. The on/off control makes the metal dust fall off without cleaning, which is convenient and simple to use..
  • Package Included:1 x Welding Ground Clamp.
  • Warm Tips: Make sure that the grounding device is in the off state when it is not in contactwith the ferromagnetic material. It can be freely controlled to open and close. When the ferromagnetic material is opened and connected, it will produce sudden and powerful suction. Do not use welding grounding to lift or transport materials..
Check Stock

Rockville RV12.2B 1200W Dual 12 Car Subwoofer Enclosure+Mono Amplifier+Amp Kit

  • Rockville RV12.2B 1200W dual 12" Car Subwoofer Enclosure amplifier+amp kit.
  • Rockville RV12.2B Dual 12” bass enclosure system with matching mono block amplifier. 1200 watts peak power/ 400 watts RMS cea-2031 rating. Dual 12” bass enclosure system with matching mono block amplifier. Quasi transmission Line cabinet design..
  • Angled at 15% for near perfect in vehicle bass alignment. Exterior: high quality aviation grade tweed Carpet. Oversize Rockville Shield embroidery. Mono, Gold-plated push style, speaker terminal. Dual, high-power, high-efficiency 12" Subwoofers..
  • 1200 watts peak power. Power output: 200 watts RMS cea-2006 power @ 4-Ohm and 97DBA (Reference: 1Watt into 4 ohms). Frequency Response: 15Hz - 20Khz (-3Db). RMS power: 400 watts @ 2 ohms. 4 ohm mono-block class A/B..
  • 17" High grade twisted pair 100% Copper RCA cables. 17' 8 gauge translucent Blue Super flex Power cable. 3' 8 gauge clear super flex ground wire. 17' 18 gauge Blue remote cable. 17' 16 gauge speaker wire. Gold Plated anl heat resistant fuse holder.
Check Stock

BAYTORY Upgrade Magnetic Welding Support Ground Clamp Tools, Welding Magnet Head Strong Magnetism Large Suction, Copper Tail Welding Accessories Stability Clamps

  • Check out this handy Fix-tite Magnetic Welding Ground Clamp. A device that speeds up grounding chores for welders..
  • NO-HASSLE SAFETY SETUP - You no longer have to waste your time finding, placing or removing a ground point for a welding job. This device serves as the ground point, which you can take with you anywhere. Simply tack this onto a convenient spot, hook up your safety wire and you're ready to weld..
  • STRONG MAGNETIC GRIP - This magnetic clamp attaches easily to any smooth metal surface, flat or curved. It holds on tightly, without budging easily. Now that you've got this, you won't have to take minutes searching for a good ground or attaching grounding tabs..
  • OFFERS CONVENIENCE - Sometimes you're faced with a welding job that has limited options for ground points. You don't want to have to damage a car's paint job simply to affix a safety line. This magnetic clamp is handy to have in such situations. You can stick in on a car body and not have to damage the paint. The clamp can also be attached to metal poles, struts, railings or the welding table..
  • Material: Copper / insulation board. Durable and solid.With copper tail with good welding stability..
Check Stock

VOLT Solid Brass 12V LED Landscape Lighting Kit (6 Spotlights, 4 Path Lights) with Transformer

  • ...der the shade to increase ground illumination. Complies with International Dark-Sky Association standards..
  • 150-WATT SLIM LINE LOW VOLTAGE TRANSFORMER – Slimmer, lighter and easy to install compared to traditional transformers. Clamp-type wire connectors allow for fast and secure connections with a stainless-steel enclosure and a lockable hinged lid. Designed specifically for LEDs, and features a toroidal core for more reliable, efficient, cooler and quieter operation than EI laminated types. Mechanical timer included..
Check Stock

MTX TNP212D2 12\ 1200 Watt 4 Ohm Dual Loaded Car Audio Subwoofer Package with Sub Enclosure, Planet 1500W Monoblock A/B Amplifier & 8 Gauge Wiring Kit

  • COMPLETE SOUND PACKAGE: Upgrade your cars sound system with this complete package that includes MTX 12 inch dual loaded car subwoofer, a sub enclosure, Planet Audio monoblock amplifier and a complete 8 gauge amp installation wiring kit.
  • CAR SUBWOOFER: The MTX Terminator series subwoofer system includes 2 subs, sub enclosure and a car amp.
  • Boasts 1200 watts max power and 400 watts RMS.
  • Features rubber surround, polypropylene cone and a 2-inch aluminum single 4 ohms voice coil.
  • SUBWOOFER BOX ENCLOSURE: This MTX enclosure features solid MDF construction and thick black carpet.
  • Dimensions (H x W x D1 x D2): 14 x 29.69 x 13.5 x 11.13 inches.
  • CAR AMPLIFIER: Planet Audio Amplifier delivers 700 watts RMS x 1 @ 4 Ohm, 1100 watts RMS x 1 @ 2 Ohm, 2500 watts RMS x 1 @ 2 Ohm max power, 1500 watt max power.
  • Switchable input sensitivity: 100mV 2V or 2V 8V.
  • Dimensions (H x W x L): 2.19 x 10 x 10 inches.
  • INSTALLATION WIRING KIT: 20-foot 8 gauge red power cable.
  • 20-foot high performance RCA interconnect.
Check Stock