Best Ddrpc12sdram 1mhz

Taidacent AD620 High Accuracy Low Cost Low Power Instrumentation Amplifier Voltage Amplifier Module Differential Amplifier Single-Ended/Differential Small Signal

  • Power supply: 5V-24V can be, but depends on how much the baby with the voltage output (if the customer requires output 5V voltage, then the AD62X series of chips is about ± 3.8V power supply, the regulator chip itself has a pressure difference, so it is recommended that the voltage is higher than 12V single Power supply is better).
  • Bandwidth: AD620/623 is lower than 50KHz at high gain and greater than 1MHz at low gain Input signal type: single-ended signal or differential signal.
  • The maximum magnification: more than 2000 times (actual measurement), due to the gain assembly resulting in greater fluctuations in the waveform band, it is recommended to use high-gain multi-stage amplification.
  • Saturation output amplitude: AC peak 10Vpp (±5Vpp).
  • This module can be enlarged 1000 times, the circuit layout is regular, MINI, design layout and wiring are reasonable.
Check Stock

Siglent SSA3021X Plus - 2.1 GHz Spectrum Analyzer with Tracking Generator and Preamplifier

  • 9KHz-2.1GHz, Phase Noise98dBc/Hz, RBW 1Hz-1MHz, Min. DANL -161dBm/Hz, Total Amplitude Accuracy0.7dB, 10.1 lnch WVGA(1024x600) Touch Screen.
  • Includes tracking generator and pre-amplifier.
  • -161 dBm/Hz Displayed Average Noise Level (DANL).
Check Stock

2 Set 24MHz 8CH 24MHz 8 Channel USB Logic Analyzer Device with EMI Ferrite Ring USB Cable UART IIC SPI Debug Compatible with Ar-duino ARM FPGA M100 SCM

  • The logic for each channel sampling rate of 24M/s. General applications around 10M, enough to cope with a variety ofoccasions.
  • Sampling rate up to: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz.
  • Input Impedance: 1Mohm || 10pF (typical, approximate).
Check Stock

2pcs USB Logic Analyzer Device with USB Cable 24MHz 8CH 24MHz 8 Channel UART IIC SPI Debug for Arduino ARM FPGA M100 SCM

  • ✹✹The logic for each channel sampling rate of 24M/s. General applications around 10M, enough to cope with a variety ofoccasions..
  • ✹✹Sampling rate up to: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz.
  • ✹✹Input voltage range: -0.5V to 5.25V.
  • ✹✹ART, SPI, IIC and other communication debugging, let you get twice the result with half the effort. 24M sampling rate, can automatically analyze UART, IIC, SPI and many other standard protocols..
  • ✹✹his item is an inexpensive logic analyzer designed to be compatible with Saleae Logic Analyzer software, but this item is not an official Saleae product. This item is also supported by the free software by Sigrok called PulseView..
Check Stock

DEVMO 24MHz 8CH 24MHz 8 Channel USB Logic Analyzer Device with EMI Ferrite Ring USB Cable UART IIC SPI Debug Compatible with Ar-duino ARM FPGA M100 SCM

  • ★The logic for each channel sampling rate of 24M/s. General applications around 10M, enough to cope with a variety ofoccasions.
  • ★Sampling rate up to: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz..
  • ★Input Impedance: 1Mohm || 10pF (typical, approximate).
  • ★UART, SPI, IIC and other communication debugging, let you get twice the result with half the effort. 24M sampling rate, can automatically analyze UART, IIC, SPI and many other standard protocols..
Check Stock

Signal Generator Kit, XR2206 Precise Function Signal Generator Frequency Module Signal Generator DIY Kit Sine Triangle Square Output Adjustable 1Hz-1MHz, 9-12V DC Input (1)

  • Good precision: the XR2206 function signal generator is precise, with a transparent case box shell for good assemble.
  • Parameters: Voltage Supply: 9-12V DC Input.
  • Sine wave parameters:Amplitude: 0-3V at 9V DC input.
  • Square wave parameters: Amplitude: 8V (no load) at 9V DC Input.
  • Triangle wave: Amplitude: 0-3V at 9V DC input.
  • Linearity: less than 1% (up to 100 KHz) 10 mA.
Check Stock

Comidox 1Set USB Logic Analyzer Device Set USB Cable 24MHz 8CH 24MHz 8 Channel UART IIC SPI Debug for Arduino ARM FPGA M100 Hot

  • This item is an inexpensive logic analyzer designed to be compatible with Saleae Logic Analyzer software, but this item is not an official Saleae product. This item is also supported by the free software by Sigrok called PulseView..
  • Sampling rate up to: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz..
  • The logic for each channel sampling rate of 24M/s. General applications around 10M, enough to cope with a variety ofoccasions..
  • A total of 8 digital channels, the voltage range is 0V and 5.5V, of which 1.5V is the voltage threshold, below 1.5V is considered low, above 1.5V is considered high..
  • UART, SPI, IIC and other communication debugging, let you get twice the result with half the effort. 24M sampling rate, can automatically analyze UART, IIC, SPI and many other standard protocols..
Check Stock

Acxico 1Pcs AM Radio Transmitter DIY 3-Channel 1MHz 3MHz 5MHz w/ Antenna Audio Cable

  • 3-channel AM transmitter 1MHZ 3MHZ 5MHZ Kit.
  • Products include: 1Set(with ANT and cable)((For the new version, the color of PCB and wire will be shipped randomly, which may be different from the color of the picture, please understand).
Check Stock

DKARDU USB Logic Analyzer Device 24MHz 8CH 8 Channel UART IIC SPI Debug with Mini USB Cable Dupont Cable 6 Colors Test Hook Clip Set for Arduino FPGA M100 SCM

  • 【Product introduction】: This item is an inexpensive logic analyzer designed to be compatible with Saleae Logic Analyzer software..
  • 【Applicable to various occasions】: The logic sampling rate of each of the 8 channels is 24M/s, generally about 10M, which is sufficient for various occasions.
  • 【Channel value】: A total of 8 digital channels, the voltage range is 0V and 5.5V, of which 1.5V is the voltage threshold, below 1.5V is considered low, above 1.5V is considered high..
  • 【Sampling rate up to】: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz..
  • 【Automatic analysis】: UART, SPI, IIC and other communication debugging, let you get twice the result with half the effort. 24M sampling rate, can automatically analyze UART, IIC, SPI and many other standard protocols..
Check Stock