Best Aluminum Cathode

DC 5-12V/15-160V Stepper Motor Drive,PWM Adjustable Stepper Motor Controller Signal Generator Speed Regulator

  • Power supply: 15-160VDC or 5-12VDC. If you are using 5-12VDC power, positive end connect DC 5-12V Input, negative end connect Common Cathode End..
  • 3 Frequency: High: 5.8KHZ-127KHZ, Mid: 590HZ-15.8KHZ, Low: 82HZ-2.3KHZ.
  • To control the stepper motor, mus connect to the driver.
  • PUL + and PUL- pulsed positive and negative.
  • EN + and EN- is to enable the positive and negative terminals.
  • DIR + and DIR- are the positive and negative directions..
  • Frequency of measurement can amount PUL and common cathode terminal (GND) two ports..
Check Stock

uxcell Common Cathode 10 Pin 1 Bit 7 Segment 1.1 x 0.79 x 0.35 Inch 0.55\ Red LED Display Digital Tube 10pcs

  • Panel Size: 19 x 12.7 x 8mm / 0.75" x 0.5" x 0.31" (L*W*H).
  • Total Size: 19 x 12.7 x 14mm / 0.75" x 0.5" x 0.55" (L*W*H).
  • Package Content: 10 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 10 Pin 2 Bit 7 Segment 1.41 x 1.02 x 0.39 Inch 0.8\ Red LED Display Digital Tube 2pcs

  • Panel Size: 35.8 x 25.8 x 10mm / 1.41" x 1.02" x 0.39" (L*W*H).
  • Total Size: 35.8 x 25.8 x 14mm / 1.41" x 1.02" x 0.55" (L*W*H).
  • Package Content: 2 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 10 Pin 2 Bit 7 Segment 0.59 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 15 x 14 x 7.2mm / 0.59" x 0.55" x 0.28" (L*W*H).
  • Total Size: 15 x 14 x 13.5mm / 0.59" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 12 Pin 4 Bit 7 Segment 1.18 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 30 x 14 x 7.2mm / 1.18" x 0.55" x 0.28" (L*W*H).
  • Total Size: 30 x 14 x 13.5mm / 1.18" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 11 Pin 3 Bit 7 Segment 0.89 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 22.5 x 14 x 7.2mm / 0.89" x 0.55" x 0.28" (L*W*H).
  • Total Size: 22.5 x 14 x 13.5mm / 0.89" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

Apera Instruments, LLC-AI1312 Apera Instruments 201T-S pH/Temp. Electrode, 8-pin Connector, The Replacement Electrode for Apera 400/400S Series Portable Meters

  • 3.Glassy carbon electrode is one of the widely used working electrodes. It is a good inert electrode with good conductivity, high hardness, high finish, high hydrogen overpotential, wide polarization range and chemical stability. It can be used as inert electrode for anodic stripping, voltammetric determination of cathode and variable valence ions, and can also be used as chemically modified electrode.
  • 4.The glassy carbon surface must be mirror and clean. Since the surface of glassy carbon is easily polluted by some organic metal compounds, which seriously affects the measurement (no peak, no impurity peak and no recurrence), it must be cleaned before measurement.
  • 5.There are three main maintenance methods, chemical method 1. Nitric acid immersion and scrubbing. 2. Soak and scrub with ammonia water, anhydrous ethanol or acetate 1:1. 3. It can also be scrubbed with alcohol and then soaked in 6nhcl or 4nho3. Electrochemical treatment: repeated polarization (reset scan) (anode cathode to cathode) in the voltage range of + 0.8V - (- 1.8V (0.5mkclph7 except o2i).
Check Stock

GOONSDS Tungsten Filament 99% Purity Tungsten Metal Wire Coil,Length 1m,Diameter 0.04mm

  • Purity: W ≥ 99% . Dimensions: diameter:0.04-0.1mm(Buy on demand) , length:1m. Package: 1 x Tungsten wire.
  • Tungsten and its alloys are widely used in electronics and power industry because of its strong plasticity, low evaporation rate, high melting point and strong electron emission ability. For example, due to its high luminous efficiency and long service life, tungsten filament is widely used in the manufacture of various bulb filaments, such as incandescent lamp, iodine tungsten lamp, etc,.
  • Tungsten wire is used to make direct hot cathode and grid of electronic oscillator tube and side hot cathode heater in various electronic instruments. The properties of tungsten make it suitable for TIG welding and other electrode materials similar to this kind of work..
  • It is widely used in aerospace, aviation, oil drilling, electrical instrument and other industries, such as manufacturing heat sink, balance weight of control rudder and contact materials of switch, circuit breaker, spot welding electrode, etc..
  • We are a supplier of high quality metal materials. We can provide you with the materials you need. You can contact us to get any materials you need.
Check Stock

Optronics Motion Pro 1000 RC-550M

  • Remote Control 500,000 Candlepower Spotlight with Suction mount - White.
  • Motion Pro remote control sealed beam spotlight, Cold cathode area light on opposite side..
  • 500,000 Candlepower Spotlight with 15 ft corded remote to adjust beam vertically and horizontally.
Check Stock