Best Ac Dc Coils

Atwood 38604

  • When your would run normally, if you hear the igniter begin to fire, then the furnace would light, then immediately go out.Maybe you can consider the problem of the sail switch..
  • This sail switch designed for rv and campers heater furnace fault use..
  • This Sail Switch Replaces Sail Switches: 35050, 35052, 35054, 35137, 36133, 37716.
  • Applicable to Models: 1522 2 STAGE, 1522 LD 2 STAGE, 2334 2 Stage, 2540 2 Stage, 7912-II, 7916-II, 7920-II, 8516-II, 8516-III, 8516-IV, 8520-II, 8520-III, 8520-IV, 8525-II, 8525-III, 8525-IV, 8531-II, 8531-III, 8531-IV, 8535-II, 8535-III, 8535-IV.
  • Applicable to Models: 8935-DC-I, 8935-AC-I, 8940-DC-I, 8940-AC-I, 8935-DC-II, 8935-AC-II, 8940-DC-II, 8940-AC-II, 8935-DC-III, 8935-AC-III, 8940-DC-III, 8940-AC-III.
Check Stock

F.S.P Sail Switch RV Camper Furnace Replacement for Atwood HydroFlame Model 36680, 36133, 31377

  • Direct Replacement for Atwood / HydroFlame Furnaces.
  • Replaces Part #s: 36680, 31377, 35050, 35052, 35054, 35137, 36133, 37716.
  • This sail switch designed for RV / Campers furnace.
  • Applicable to Models: 1522 2 STAGE, 1522 LD 2 STAGE, 2334 2 Stage, 2540 2 Stage, 7912-II, 7916-II, 7920-II, 8516-II, 8516-III, 8516-IV, 8520-II, 8520-III, 8520-IV, 8525-II, 8525-III, 8525-IV, 8531-II, 8531-III, 8531-IV, 8535-II, 8535-III, 8535-IV.
  • Applicable to Models: 8935-DC-I, 8935-AC-I, 8940-DC-I, 8940-AC-I, 8935-DC-II, 8935-AC-II, 8940-DC-II, 8940-AC-II, 8935-DC-III, 8935-AC-III, 8940-DC-III, 8940-AC-III.
Check Stock

Leviton 47605-PSC Versatile Power Supply for Structured Media Cabinet

  • LED: This Green LED will illuminate when input AC power has been applied to the unit and DC power is available.
  • Fuse: If the AC/DC primary circuit load or if the DC output load increases, causing the input AC current to the DC power supply to exceed the 2 Amp....
  • This will cause the DC power supply to loose all DC power output but AC power output to the NEMA 5-15 Receptacles will remain active.
  • This unit connects to a 120 VAC, 3 wire source and provides 6 DC outputs at 12 Volts.
  • NEMA 5-15 Receptacles: These two AC output female connectors will provide 120 VAC and UL rated at 15 Amps total.
Check Stock

UMLIFE 4PCS AC/DC to DC Step Down Buck Converter AC 5-30V DC 5-48V 24V 36V 48V to DC 2.5-35V 12V Voltage Regulator Board 2A Adjustable Volt Power Supply Module

  • 4PCS LM2596HV AC/DC to DC Buck Step Down Converter Module 3v 3.3V 5V 6V 9V 12V 15V 24V DC 5V-50V Adjustable Step-Down 3A Power Supply.
  • Adjustable AC/DC to DC buck converter power supply module Voltage Regulator.
  • Input ac voltage AC5V~AC30V or dc5v-50v. Due to the large fluctuation of ac voltage, the recommended ac voltage range has been reserved..
  • The power module adopts plug-in LM2596HV, LM2596 version of high voltage, the highest input voltage is 50V(limited by filter capacitor voltage) with external radiator, can withstand high current work..
  • Input voltage range: AC 5V-30V, DC 5V-50V Output output range: DC 3.3V-33V.
Check Stock

Car & Freezer

  • Adjustable temperature range: -8°F to 50°F.
  • “Fast Freeze” mode rapidly cools to -8°F.
  • Voltage power AC (115V/ 60Hz – 70W/1.0A A) or DC (12V/24V – 5.2A /2.6A Car Lighter Socket).
  • unit can be plugged in with both AC power and the DC power at the same time. If both AC and DC are plugged in at the same time, then the unit will primarily operate on AC. If the AC power source fails, DC will become primary power supply source..
  • 8-feet AC power cord and 10-feet DC power cord.
  • Tough and solid outer powder coated steel housing.
  • Wattage: 70 Watts. Net weight: 52 LB. Internal dimensions: 21" W x 10" L x 15" H including a compressor step with 7.25″ W x 7.5″ H.
Check Stock

Klein Tools ET45VP Voltage and GFCI Receptacle Tester, AC/DC Voltage Electrical Test Kit

  • AC/DC Voltage and GFCI Receptacle Outlet Test Kit.
Check Stock

Fluke TL75 Hard Point Test Lead Set

  • The 117 multimeter measures AC and DC voltage as well as AC and DC amps. The 323 clamp meter measures AC and DC voltage as well as AC amps.
  • The 117 multimeter features true RMS for accurate measurements on non-linear loads.
  • The 117 multimeter features low input impedance which helps prevent false readings due to ghost voltage.
  • The 323 clamp meter provides a true RMS AC voltage and current for accurate measurements on non linear signals.
  • The 323 clamp meter measures 400 A AC current and 600 VAC and DC voltage.
Check Stock

T-Power Ac Dc Adapter Compatible for Turnigy Accucel 6 Lipo A123 NiMH NiCd (50w 6a - only) Replacement Switching Power Supply Cord Charger Wall Plug Spare

  • T-Power (TM) Made with the highest quality / Input Voltage Range: AC 100V - 240V / OUTPUT : 12V DC 60W ( DC 11.0~18.0V compatible ).
  • Compatible With: Turnigy Accucel 6 Lipo A123 NiMH NiCd / Turnigy Accucel-6 50W 6A Balancer Charger LiPo LiFe NiMh NiCd JST-XH / ((King HKC6, HobbyKing 50watt 5A X-Charger/Balancer, and HobbyKing ECO6 50W 5A Channel Well Technology (CWT) for Turnigy Model: CAD060121 (newer version of PAA060F)) Tenergy TB6AC 50W/5A AC/DC Dual Power Balancing Tenergy B450AC 45W AC/DC Compact Balance.
  • Tenergy TB6AC 50W/5A AC/DC Dual Power Balancing Tenergy B450AC 45W AC/DC Compact Balance.
  • Compatible With: SKYRC iMAX B6 Mini Professional Skyrc Imax B6 Professional Rapid Lipro SKYRC iMAX B6AC V2 Dual Power (50Watts) LiPo,LiHV,LiIon,LiFe,NiCd,NiMH,Pb SkyRC Quattro 1S Lipo Micro Battery Charger ( FOR Micro/Micro Reverse/MX/mCPX ) Compatible With: SKYRC iMAX B6AC V2 Dual PoweriMAX B6AC Version 2 Digital LiPo LiIon LiFe GoolRC B6 Mini Professional Balance Charger/Discharger for LiPo Lilon LiFe NiCd NiMh Pb RC Battery.
  • ❌ ((( NOTE ! THIS ITEM WILL NOT FIT : 80W Accucel 6 Digital charger High Power (80W) 10a ))).
Check Stock

Fluke 117/323 KIT Multimeter and Clamp Meter Combo Kit

  • The 117 multimeter measures AC and DC voltage as well as AC and DC amps. The 323 clamp meter measures AC and DC voltage as well as AC amps.
  • The 117 multimeter features true-rms for accurate measurements on non-linear loads.
  • The 117 multimeter features Low input impedance which helps prevent false readings due to ghost voltage.
  • The 323 clamp meter provides a true RMS AC voltage and current for accurate measurements on non-linear signals.
  • The 323 clamp meter measures 400 A AC current and 600 VAC and DC voltage.
Check Stock